196396 Iss 2 Nov 2015 - Semi Appendix Manual.pdf - 第62页
PREVENTIVE MAINTENANCE MACHINE INFORMATION Chapter Issue 5, Aug 14 Technical Reference Manual 28.1 CHAPTER 28 PREVENTIVE MAINTENANCE MACHINE INFORMA T ION The maintenance engineer should complete the following informatio…
PNEUMATIC MODULE
PNEUMATIC SCHEMATICS
Chapter Issue 2, Aug 14 Technical Reference Manual 24.5
Figure 24-2 Pneumatic Schematic Sheet 2
To Pneumatic Supply See Sheet 1
For Topside Referencing System
(TRS) p
s - the TRS chapter.neumatic upply See
HTC Aux Conveyor Board Stops
L-R=
L/H D’Line
Board Stop
L-R=
R/H UpLine
Board Stop
L-R=
R/H D’Line
Board Stop
M27SOL02
M27SOL03
M27SOL01
R/H Conveyor
Solenoids
5/2
16SOL10
AB
Clamp
Speed
Control
Unclamp Delay Control
Fitted at Solenoid
Valve on Rear of M/C
Board Clamps
Snuggers Option
Snuggers
Out
In
Pressure Control
Snuggers On
Snugger
Delay
Control
Board Clamp
Reg (optional)
In Out
Air Ionizer Option
Out
In
See Sheet 1
PREVENTIVE MAINTENANCE
MACHINE INFORMATION
Chapter Issue 5, Aug 14 Technical Reference Manual 28.1
CHAPTER 28 PREVENTIVE MAINTENANCE
MACHINE INFORMATION
The maintenance engineer should complete the following information boxes
as a permanent record of the machine details.
Machine Serial Number
Line Number
Customer
Engineer
PREVENTIVE MAINTENANCE
INTRODUCTION
28.2 Technical Reference Manual Chapter Issue 5, Aug 14
INTRODUCTION
Philosophy Recommended Preventive Maintenance (PM) is to be performed daily and
monthly as defined in the programme.
If any items or parts are found to be defective, please contact your local ASM
agent.
The PM must be adhered to in the order that it has been presented.
The plan follows the same procedures employed in the ASM Equipment Utili-
zation Programme (EUP), information has been reproduced here as a guide for
customers who wish to develop a comparable programme that conforms to the
ASM standard. For more information on how to obtain the ASM EUP please
contact your local ASM agent for details.
The Preventive
Maintenance
Schedule
Each process of the service programme is only described in enough detail to
act as guidance to those ASM authorized personnel using it.
The daily schedule can be performed by a suitably trained operator, the tasks
should take approximately 15 minutes.
The monthly schedule consists of two modules each taking approximately 2
hours to complete. These modules are to be carried out by ASM authorized
personnel who have successfully completed the ASM Maintenance Course.
Information in this chapter can be photocopied or if accessed via the Internet,
downloaded for printing. The pages which are reproduced can be stored away
as the PM record of the machines’ service history.
Material Safety
Data Sheets
Material Safety Data Sheets (MSDS) listing the health and safety aspects
applicable to consumables such as cleaning materials, oils and greases are
available on request from the purchase source.
If difficulty is experienced in obtaining any MSDS, assistance is available from
ASM.
Contact your local ASM agent.
Disposal of Waste
Materials
All waste materials including fluids and contaminated materials must be dis-
posed of in accordance with national, federal or local legislation.
Warranty Compliance with the preventive maintenance procedures described in this
chapter is an essential element of the machine warranty policy as defined in the
‘ASM Standard Warranty Statement’.