Formflex Manual.pdf - 第29页
2.6 FormFlex Tooling Manual Chapter Issue 4 Jun 04 MACHI NE P ROGRA MMING FORMF LEX SETUP 34. Select Auto Board (F1) . 35. Remove t he board fr om the rai ls and sel ect Change Scr een (F5). 36. Raise the fron t printhea…
MACHINE PROGRAMMING
FORMFLEX SETUP
Chapter Issue 4 Jun 04 FormFlex Tooling Manual 2.5
26.Press the amber operator button on the machine front cover.
27.The operator button flashes amber during setup. Wait until the operator
button displays continuous amber to indicate that the setup is complete.
28.Remove the downhold mechanism and the FormFlex setup plate from the
tooling area.
29.Close the front printhead cover.
30.Press the System button.
31.Select Exit (F8).
32.Select Exit (F8).
The following window and menu bar is displayed:
33.Select Continue (F1).
Exit
Vision
Height
Raise
Head
Exit
Leaving Generic Tooling
WARNING You are about to return
to the Setup Page
Clear all tooling setup
equipment before proceeding
Continue Cancel
Continue Cancel
2.6 FormFlex Tooling Manual Chapter Issue 4 Jun 04
MACHINE PROGRAMMING
FORMFLEX SETUP
34.Select Auto Board (F1).
35.Remove the board from the rails and select Change Screen (F5).
36.Raise the front printhead cover/shutter.
37.Ensuring correct orientation, fit the correct screen for the product loaded.
NOTE
If squeegees were removed in Step 9, these are to be refitted at this point.
38.Lower the front printhead cover/shutter.
39.Press the System button.
40.The FormFlex setup is now complete.
Auto
Board
Manual
Board
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Too lin g
Change
Language
Exit
MACHINE PROGRAMMING
RESETTING FORMFLEX
Chapter Issue 4 Jun 04 FormFlex Tooling Manual 2.7
RESETTING FORMFLEX
1. Select Change Screen.
2. When prompted, open the front printhead cover/shutter.
3. Remove the stencil.
4. Press the green reset button to lower the pins on the tooling modules.