WPC an:on SIPLACE SX1:SX2 Montageanleitung : Assembly Instructions.pdf - 第67页
4 Operator Tasks Mo nt ag ea nl ei tu ng / A ss em bl y In st ru ct io ns W PC a n/ on S IP LA CE S X1 /S X2 - 0 3/ 20 25 67 4.3 Undocking the WPC5/WPC6 Preparatory steps ► Go to Manual operations => Entire machine fu…
4 Operator Tasks
66 Montageanleitung / Assembly Instructions WPC an/on SIPLACE SX1/SX2 - 03/2025
Setting the exact height of the WPC5/WPC6
Fig.21: Setting the height of the WPC5/WPC6
► Use a measuring scale to adjust the WPC5/WPC6 to the correct height through the opening (1)
on the cover plate of the feed axis.
► Use the gauge to measure the height of the WPC5/WPC6 from the white sliding surface of the
waffle pack tray carrier (2) to the aluminum block on the changeover table insert (3). The correct
height should be 87±0.5mm.
► If the height is outside the specified value, adjust each foot accordingly to lower or raise the
WPC5/WPC6 to the correct height.
4.2 Switch on the WPC5/WPC6
NOTICE
Start up sequence with two WPCs
In case of two WPCs on one machine the start up sequence has to be observed. Otherwise some er-
rors (CAN switch errors) may occur.
► Always switch on the WPCs first and then the machine.
► On machines of type SX1/SX2 as well as DX1/DX2 with two WPCs, both WPCs must be
switched on simultaneously with the machine (within 12 sec.).
If not, the CAN switch switches into the "error" state.
4 Operator Tasks
Montageanleitung / Assembly Instructions WPC an/on SIPLACE SX1/SX2 - 03/2025 67
4.3 Undocking the WPC5/WPC6
Preparatory steps
► Go to Manual operations => Entire machine functions and perform a Overall reference run.
► Perform a WPC reference run. To do this, select Manual operations => Subsystems => WPC
and click on Reference run.
► Use the software to move the lifting axis of the WPC5/WPC6 into the transport position. To do
this, select the Move into transport position button. The WPC5/WPC6 will be moved to a
defined position, from which it can be safely transported.
► Disconnect the WPC5/WPC6 from the power supply and the data supply.
Removing the WPC5/WPC6
► Open the machine covers on the relevant changeover table.
► Move the changeover table out of the machine.
► Fasten the hexagonal shaft (crank handle) to the lifting mechanism of the WPC and turn in a
clockwise direction as long as there is enough free space to lift the WPC5/WPC6.
NOTICE!
Do not turn further than necessary to pull the WPC5/WPC6 away! The feed mechanism must not
get caught!
.
► Remove the WPC5/WPC6.
Transportation of the WPC5
► When the lifting axis is in its lowermost position (transport position), the WPC5/WPC6 can be
moved on a level floor.
CAUTION
Transport on a pallet truck – always turn the chassis all the way up!
► Always rotate the chassis all the way up! Otherwise, the WPC weight will press down on the
chassis' lifting spindle, causing the spindle to bend!
4 Operator Tasks
68 Montageanleitung / Assembly Instructions WPC an/on SIPLACE SX1/SX2 - 03/2025