CP6 series maintenancech45 周保养.pdf - 第4页

1.3 Cleaning the W aste T ape Box (Every 8 Hours) Point Tape cut by the waste tape cutter travels through a tube to the waste tape box. Empty the waste tape box every eight hours, as a large amount of waste tape collects…

1.2 Cleaning the Fluorescent Disk (Every Month)

Point

If dust or other fine particles build up on the fluorescent disk, the percentage of UV light

reflection from the station 6 UV lamp will be reduced. If this reflected light is

insufficient, a proper image can not be captured during vision processing. Vision

processing errors thus occur and placing performance drops.

Procedure

If a certain nozzle consistently causes pickup errors, clean its fluorescent disk with a soft

brush (the type of brush used for cleaning a camera lens is best).

Note : Do not rub the fluorescent disk with a rag. Rubbing the fluorescent disk makes grime

adhere to the disk, which causes vision processing problems. If grime cannot be removed,

replace the fluorescent disk.

Chapter 4 Cleaning and Lubrication

Version 11.1 4-1-2 CP-6 Series Maintenance

1.3 Cleaning the Waste Tape Box (Every 8 Hours)

Point

Tape cut by the waste tape cutter travels through a tube to the waste tape box. Empty

the waste tape box every eight hours, as a large amount of waste tape collects after eight

hours of production.

Procedure

When cleaning out the waste tape box, check the filter above it, and, if necessary, clean

the filter with a vacuum cleaner.

Filter

Waste tape box

CP6ML002E

CP-652C

Chapter 4 Cleaning and Lubrication

Version 11.1 4-1-3 CP-6 Series Maintenance

1.4 Cleaning the Tape Suction Path (Every 8 Hours)

Point

After the end of the tape is cut off by the cutter, it is drawn into the suction path in the

course indicated by the arrows. If this area becomes blocked by waste tape, tape feed

will be impeded and part pick-up will be unreliable.

Procedure

WARNING

Always be sure to cut off the 200 V power before carrying out any

work.

Inspect this area for blockage if tape feed abnormalities cause pick-up errors during

automatic production.

Do not use an air gun to blow out any waste tape that becomes clogged in the duct but

rather use a vacuum cleaner to suck the waste tape out.

Duct pipe

Feeder

CP6ML003E

Chapter 4 Cleaning and Lubrication

Version 11.1 4-1-4 CP-6 Series Maintenance