CP6 series maintenancech45 周保养.pdf - 第53页
5. Conveyor Belt Replacement Point Replace the board conveyor belt if it becomes cut or otherwise damaged. Procedure W arning Always be sure to cut out the 200V power before carrying out any work. 1. Remove the motor cov…
Notes:
Chapter 5 Replacing Consumable Parts
Version 11.0 5-4-2 CP-6 Series Maintenance
5. Conveyor Belt Replacement
Point
Replace the board conveyor belt if it becomes cut or otherwise damaged.
Procedure
Warning
Always be sure to cut out the 200V power before carrying out any
work.
1. Remove the motor cover.
2. Loosen the fixed bolt on the tension pulley to loosen the belt tension.
3. Loosen the belt guide bolts.
4. Replace the belt.
5. Insert a 0.3 mm filler gauge between the plate and the top of the belt, and tighten
the guide belt bolts, while maintaining this 0.3 mm gap.
6. Adjust the strength of the pulley tension to 1 to 1.5 kg, and tighten the tension
pulley bolts. Refer to the arrows in figure above for the direction in which the
tension pulley should be moved to increase the tension. If possible, use a tension
gauge to confirm the 1 to 1.5 kg while fixing the tension pulley. If a tension gauge
is not used, tighten the tension pulley bolts while pressing the tension pulley 1 to 2
mm, when the belt does not have any slack. (1 to 1.5 kg for the pulley strength is
approximately 1 to 2 mm.)
Motor cover
Tension pulley
Belt guide bolt
CP6MR005E
Chapter 5 Replacing Consumable Parts
Version 11.0 5-5-1 CP-6 Series Maintenance
Notes:
Chapter 5 Replacing Consumable Parts
Version 11.0 5-5-2 CP-6 Series Maintenance