DR_A_MANUAL.pdf - 第6页

Glass Solder Collector Cleaning 1 . Rem oving th e lid 3. Inser ting the glass solder collector Check filter Lid Ch eck internal j oint 2. Cleaning Che ck th e fil ter and re pla ce it if i t is dir t y or damaged. Re mo…

100%1 / 20
1. Removing
Loosen the deposit lid (a),
remove the screw (b)
and withdraw the heating
element (c).
For this operation, turn off the station or disconnect the tool and wait until the tool temperature
drops to room temperature.
2. Placing
Insert the new Heating
Element (a), tighten the screw
(b) and then the lid (c).
Before placing, make sure
to insert the internal gasket
into the Glass Solder Collector.
b
a
c
b
c
a
!
!
Important
For a proper connection
it is essential to insert the
cartridge by lining it up to
the mark .
washer
Changing the heating element (Ref. DSV-DR)
Compatibility
The DSV-DR also works with
the previous version DR5600
Desoldering Iron (Ref. 5600010).
In this case, you must take out
the washer with a pliers.
www.jbctools.com
5
Glass Solder Collector Cleaning
1. Removing the lid
3. Inserting the glass solder collector
Check filter
Lid
Check
internal joint
2. Cleaning
Check the filter and replace it if it is dirty or
damaged.
Remove the coil and clean the inside of the glass
solder collector with the cleaning stick.
The lid must be unscrewed with the DR560 in a
vertical position.
The glass solder collector must be inserted
with coil filter in place, positioned between the
2 lines marked.
Then the whole unit must be closed by
screwing the lid.
Marks
6
Maintenance
Before carrying out maintenance or storage, always unplug the tool.
- Check periodically that the metal parts are clean to ensure it is detected when on the stand.
Always use a damp cloth or alcohol.
- Periodically check all cables and tubes connections.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
The intake tube should be periodically cleaned by the largest rod.
Tip Care
Important
DO NOT press the vacuum pump button while tinning the desoldering tip, as the fumes given off
by the flux would quickly block the ducts and the air filter.
www.jbctools.com
7