Schneller MTC Wechseltisch.pdf - 第45页

Special design Assembly instructions Changeover table in place of the MTC2 03/2007 Edition 45 2 2 2.12 Removal : Reverse the order described ab ove to remove the table. It is not necessary to uninstall th e software even…

100%1 / 48
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
44
2
2.10 Calibration
The table can be calibrated using the iron-type gauge in SITEST. 2
Feeder position detection is also possible. 2
2.11 Job changes in SIPLACE Pro
The following procedure is recommended: 2
: Stopp the old job.
: Remove the MTC/changeover table.
: Install the changeover table/MTC.
: Start the new job.
2
2
It can come to troubles in the CAN bus system at non-observance. A restart of the placement
machine is inevitable. 2
Special design Assembly instructions Changeover table in place of the MTC2
03/2007 Edition
45
2
2
2.12 Removal
: Reverse the order described above to remove the table.
It is not necessary to uninstall the software even if using the MTC. 2
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
46
2.13 Circuit diagram
2
Fig. 2.10 - 1 Circuit diagram