00194385-01.pdf - 第28页
Installation of retaining clamp f or lifting axis/alignment of spindle/check of gear fixing for spindle, MT C2 06/2004 Edition 28 : Check the lo cation of the gr ub screw . If ther e are gr ub screw s in both holes, th e…
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
27
2
2
2
2
2
2
2
2
2
Position of the ball bearing on the supporting bracket
Supporting bracket
Reach through
this opening
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
28
: Check the location of the grub screw. If there are grub screws in both holes, the retaining
clamps do not have to be retrofitted.
If a grub screw is missing from one of the two holes, the retaining clamps will have to be retro-
fitted, and the assembly steps are different for each clamp (see image).
2
: Continue from the next section or the section after that, depending on the location of the hole.
2.4.1 Inserting the retaining clamp if the hole is at the back
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
The following photographs were taken with the supporting bracket removed for greater clarity. 2
2
: Remove the size 4 hexagon socket head screw and keep on one side.
2
Assembly for hole at back
Assembly for hole at front
Cassette holder
Remove this screw
(small ratchet screw-
driver with size
4 hexagon head)
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
29
: With your hand, press the stripper sleeve down and guide the pin of the retaining clamp into
the flanged nut at the position shown.
2
Do not introduce into the stripper sleeve. 2
2
2
2
2
2
2
2
Stripper sleeve
Retaining clamp
Flanged nut