00194385-01.pdf - 第32页
Installation of retaining clamp f or lifting axis/alignment of spindle/check of gear fixing for spindle, MT C2 06/2004 Edition 32 : Loose n the s ix screws i n order to pull th e plate forward. 2 2 : Pull the doc king pl…
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
31
2.4.2 Inserting the retaining clamp if the hole is at the front
: Disconnect both plugs from the motor.
2
2
: Mark the positions of the docking plate on the bases (using a felt-tip pen, etc).
2
2
Remove both plugs
Mark the positions here
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
32
: Loosen the six screws in order to pull the plate forward.
2
2
: Pull the docking plate forward in order to access the flanged nut.
It may be necessary to undo some cable ties in order to do this.
2
: Loosen the screw using the ratchet screwdriver with the size 4 hexagon head.
2
2
2
Loosen six screws
on the docking plate
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
33
: Guide the pin of the retaining clamp into the flanged nut at the position shown in the picture.
2
Do not introduce into the stripper sleeve. 2
2
2
2
: Fix the retaining clamp using the screw (see top picture).
2
: Line up the docking plate with the marks you made earlier in order to screw in place, then fix
using the six screws.
2
2
2
Retaining
clamp
Hole for the pin of the retaining clamp
Screw