00194385-01.pdf - 第29页
Installation of retaining clamp for lif ting axis/alignment of spindle/check of gear fixing for spindle, MTC2 06/2004 Edition 29 : With yo ur hand, p ress th e stripp er slee ve dow n and guid e the pi n of the retaining…
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
28
: Check the location of the grub screw. If there are grub screws in both holes, the retaining
clamps do not have to be retrofitted.
If a grub screw is missing from one of the two holes, the retaining clamps will have to be retro-
fitted, and the assembly steps are different for each clamp (see image).
2
: Continue from the next section or the section after that, depending on the location of the hole.
2.4.1 Inserting the retaining clamp if the hole is at the back
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
The following photographs were taken with the supporting bracket removed for greater clarity. 2
2
: Remove the size 4 hexagon socket head screw and keep on one side.
2
Assembly for hole at back
Assembly for hole at front
Cassette holder
Remove this screw
(small ratchet screw-
driver with size
4 hexagon head)
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
29
: With your hand, press the stripper sleeve down and guide the pin of the retaining clamp into
the flanged nut at the position shown.
2
Do not introduce into the stripper sleeve. 2
2
2
2
2
2
2
2
Stripper sleeve
Retaining clamp
Flanged nut
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
30
: Turn the retaining clamp over to the left and insert the screw once more.
Only lightly tighten the screw so that the clamp can still be moved.
2
2
: Press the retaining clamp against the flanged nut using a suitable tool as shown in the picture
so that the clamp lies fully against it, then tighten the screw.
2
2
2
2
The clamp must lie fully against the nut to prevent the aluminum cover of the spindle nut flapping
up. 2
2
2
2
Retaining clamp
Screw