00194385-01.pdf - 第38页

Installation of retaining clamp f or lifting axis/alignment of spindle/check of gear fixing for spindle, MT C2 06/2004 Edition 38 : Now pre ss the P ke y on t he Mas terDrive fo r the lifting axes for the r ight and left…

100%1 / 42
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
37
2.6.1 Assembly
: Reset the basic height of the MTC2 to the original value (see operating instructions for MTC2).
: Screw the cover shown in the picture back on again on the right and left.
Do not refit the other covers.
2
2
: Dock the MTC2 into the placement machine again.
2
Make sure that there are no people around the placement machine since there are live, unpro-
tected parts in the machine during the following steps. 2
Never reach into the openings while the MTC2 is plugged in since the axes can move. 2
2
: Plug in the power plug of the MTC2.
: Carry out a reference run.
: Insert the two bottom cassettes into the tray supplies once more.
2
2
2
2
Cover
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
38
: Now press the P key on the MasterDrive for the lifting axes for the right and left sides.
r000 appears on the MasterDrive display.
: Press the Up arrow key until the display reads r004.
: Press the P key again.
2
: Carry out several MTC2 reference runs.
As the tray supply moves up, read the current value on the MasterDrive display.
: Enter the two values for tray supply 1 and tray supply 2 on the form provided. When the work
is finished, fill this form out in full and fax it to the fax number shown on the form (+49 89 20800
35130).
2
: Switch the MTC2 off at the main switch.
: Remove the power plug from the MTC2.
: Dock the MTC2 out of the placement machine.
2
: Fit the remaining four covers and the two metal rails.
: Dock the MTC2 in again.
: Plug in the power plug of the MTC2 once more.
: Switch the MTC2 on at the main switch.
2
2
2
2
2
2
2
2
2
2
2
2
39
Siemens AG
L&A
Electronics Assembly
SM SE SCC
Service Competence Center 2
Fax number: +49 89 20800 35130 2
2
Customer name
Serial number MTC2
Customer address
Current value - tray supply 1
Current value - tray supply 2
Date
Engineer