00194385-01.pdf - 第35页

Installation of retaining clamp for lif ting axis/alignment of spindle/check of gear fixing for spindle, MTC2 06/2004 Edition 35 2.6 Aligni ng the spindl e During th e alignme nt proce ss, it wi ll be nec essar y to dock…

100%1 / 42
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
34
2.5 Checking the gear wheel on the spindle
2
2
2
2
: Check that the screws used to fix the gear wheel onto the spindle are seated firmly.
Tighten the screws using a diagonal sequence.
2
2
2
CAUTION DANGER OF TIPPING 2
: Move both tray supplies into the penultimate refill position for the tray supply.
: Crank the MTC up as high as possible to allow better access to the screws.
DO NOT raise the MTC using lifting equipment (such as a fork-lift) and then stand underneath
the MTC to work. 2
2
Check that the screws are seated firmly
and tighten using a diagonal sequence
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
35
2.6 Aligning the spindle
During the alignment process, it will be necessary to dock the MTC in and out of the placement
machine several times. 2
2
: Carry out a reference run for the MTC2.
It moves right up.
: Remove all the cassettes.
: Move the MTC roughly to the penultimate pick-up position so that the lifting axis is as far as
possible in the bottom position.
: Loosen the four screws as shown in the picture.
The aluminum block should now be in the correct position on the spindle nut.
2
2
: Tighten the screws using a diagonal sequence.
2
Screws
Screws
Installation of retaining clamp for lifting axis/alignment of spindle/check of gear fixing for spindle, MTC2
06/2004 Edition
36
: Loosen the four screws on the top spindle block (see photograph).
: Remove the two screws used to fix the plate, then remove the plate.
Turn the screws loosely in the thread without tightening them.
2
: Move the tray supply into the top position.
The spindle can now be aligned.
If the spindle block is moved as the tray supply rises, the spindle was twisted when it was fitted.
It is now aligned correctly.
: Refit the plate and tighten the screws using a diagonal sequence.
: Move the tray supply into the refill position and insert a cassette.
2
2
2
2
Make sure there is a gap between cassette and plate. 2
2
2
2
2
2
2
Screws
Plate