Queue-Inspection-Manual-REV-G-2.pdf - 第7页
Queue/In spectio n Revision G / January 2022 Page 7 of 21 Do no t smoke ne ar the mac hine. Al ways hav e a fire ex ting uisher av ailable for e mergen cy u se. Be fore perfor ming any r epairs or mainten ance t o the sy…
Queue/Inspection
Revision G / January 2022
Page 6 of 21
Safety
Certain warning symbols are affixed to the machine and correspond to notations in this
manual. Before operating the system, identify these warning labels and read the notices
described below. Not all labels may be used on any specific system.
Always wear approved safety glasses when you operate or work near the
workcell.
Before you operate the system, read and understand the manuals provided
with the unit.
Never put hands or tools in areas with this symbol when the machine is in
operation. A dangerous condition may exist.
Read and understand the manuals provided with the unit before any repairs
or maintenance is done. Only a qualified individual should do service.
Use caution when there are pressurized vessels. Find and repair any leaks
immediately. Always wear appropriate safety equipment when you work
with pressurized vessels or vessels that contain chemicals
Shear hazard from moving parts. Avoid contact.
Do not remove protective guarding.
In situations where inattention could cause either personal injury or damage
to equipment, a warning notice is used.
Queue/Inspection
Revision G / January 2022
Page 7 of 21
Do not smoke near the machine. Always have a fire extinguisher available
for emergency use.
Before performing any repairs or maintenance to the system, turn off power
and lock out the power disconnect switch.
Warning notices are used to emphasize that hazardous voltages, current,
temperatures, or other conditions that could cause personal injury exist in
this equipment or may be associated with its use. Only qualified personnel
should enter areas designated with this symbol.
Laser light source present. Do not stare directly into the beam. Do not use in
the presence of highly reflective surfaces
Pinch hazard from moving parts. Avoid contact.
Hot surface. Avoid contact.
Warning, Ultraviolet (UV) light hazard. Do not look directly at the UV light
source.
Queue/Inspection
Revision G / January 2022
Page 8 of 21
Theory of Operation
The PVA Queue/Inspection module is a board transfer and inspection machine. It is SMEMA
(Surface Mount Equipment Manufacturers Association) rated for easy integration into a
production line and designed to operate with PVA dispense systems.
Any uses other than listed above could result in a dangerous condition and cannot be
protected against by the safety features installed on the system.
Figure 1: PVA Queue/Inspection Module Functional Block Diagram
Personal Protective Equipment
Operators must use eye protection because material contents are under pressure. Always
wear gloves when handling materials and solvents. Refer to MSDS sheets on the material
being dispensed for other precautions.
Waste Disposal
Dispose of all used parts and materials in accordance with local laws and regulations.
Materials and Chemicals
There are no dangerous materials or chemicals used in the operation of the machine. Refer
to the MSDS sheet on the material being cured.