ISM-1100_INM.pdf - 第6页
Quick reference handbook Barcode Reader software Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction forbidden Page 6 On the window title bar, you can see: - Ver.: 2.0.2 .4: it indica te…
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 5
AutoSMD Barcode reader – Cam viewer
“State: Running” means the program is working properly.
If you see the message Camera not connected, it means that the software
cannot recognize the camera. The reason can depend on two possibilities, either
the drivers are not installed, or the camera is not connected.
Before opening the window cam viewer, a pop-up will be displayed.
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 6
On the window title bar, you can see:
- Ver.: 2.0.2.4: it indicates the version of the Barcode reader program (currently
the 2.0.2.4 is the latest)
- uEye 4.82.17: it is the software version of the camera
- DTKx86: it is the library used by camera. In this case, the pc is a 32 bit pc and
it uses the DTK DLL. If you use Halcon DLL, you will see the Halcon library (last
version 13) instead of the DTK (last version 4.2.130)
- Save image: you can save the images you are seeing
At the bottom, you can see the following buttons and links:
Elevator Up/Down: it is needed to lift or lower the accumulator. To make tests
about the reading of the barcodes, the accumulator needs to be up.
Refresh image: it is needed to refresh the image.
Tester: it checks the colour dentification for 7” reels
7”A: it checks the barcode located in the “A” area
7”B: it checks the barcode located in the “B” area
15” A: it checks the barcode located in the “15 A”
area
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 7
7” or 15” Configuration: it sets up the parameters for reading the code on the
7” reels or 15” reels.
Only for ISM1100/ISM2000, in the upper right corner, these following details will
be shown:
Colour: it indicates the colour of the case and the size
HUE: it indicates the chromatic scale
Saturation: it indicates the saturation of the colour
ms: it indicates how long the camera takes to find the colour in millisecond
In Ultraflex 3600 machine, the cases have the same colour because the material
is ESD and it is always yellow.
In each case, there could be two reels (7”A and 7”B) and in the middle side the
operator can place other material.
To test about the reading of the barcode, you have to use the TESTER button.
After clicking the TESTER button and choosing the area to check, a new window
will appear on the bottom-right side which shows all information about the
barcodes in the selected area.