SOM-1740-001.pdf - 第4页

Contents Page 0310-001 3 Tg0934-PM-SO Before Use ................................................................................................... 1 Contents ............................................................…

Before Use

• Identifying Alert Icons

: This symbol mark represents danger or prompts

warning.

: This symbol mark represents prohibited operations.

: This symbol mark represents forced operations or

instructions.

2. Explained in this manual are only the items different from

those in the instruction manual of the main machine.

Use the instruction manual of the main machine together

with this manual.

3. The contents of this manual are subject to change without

prior notice.

Please contact our marketing department or sales ageny for

the detailed information on these special specifications.

0310-001 2 Tg0934-PM-SO

Contents

Page

0310-001 3 Tg0934-PM-SO

Before Use ................................................................................................... 1

Contents ....................................................................................................... 3

1. Scope ..................................................................................................... 4

2. Specifications ......................................................................................... 4

3. Sketch Drawing ...................................................................................... 5

3.1 Tape Feeder with width of 8 to 44 mm ............................................. 5

3.2 Bulk Feeder ....................................................................................... 6

4. Operation Description ............................................................................ 7

5. Pick-up Error Confirmation Plate Replacement Procedure ................... 8

6. Trouble Shooting .................................................................................... 9

6.1 Error Display ..................................................................................... 9

6.2 Recovery Procedure from Error Display ........................................... 10

7. Materials ................................................................................................. 13

7.1 Layout of Sensors and Loads ........................................................... 13

Layout of Sensors and Loads (Rear Side of Main Machine) ............ 13

7.2 Electrical Circuit Diagram ................................................................. 14

I/O Board H1 1/2 ............................................................................... 14

7.3 Cord Connection Diagram ................................................................ 15

Cord Connection Diagram (H1/H3 Boards) ...................................... 15

4 Tg0934-PM-SO0310-001

1. Scope

This specially designed machine detects whether any large component

is caught between the tape feeding surface of the tape feeder and the

suppressor (the vertical component), due to a pick-up error in the large

component, resulting from the component's pick-up height having not

been correctly set.

This machine immediately stops the feeder carriage, after detecting the

error, so as to prevent interference of the line sensor unit by the large

component.

2. Specifications

Item Description

1. Functions

2. Applicable Compo-

nent

3. Detection Method

4. Detection Timing

5. Others

This specially designed machine has the following functions.

• Large component pick-up error detection

• Feeder carriage stopping function after detecting the error

Size: 26

× 26 mm or less

Note: If the component is placed 2.8 mm or lower than the tape feeder

feed reference surface then the error can not be detected, be-

cause the component has been placed below the pick-up error

confirmation plate.

Detection System

Actuator Plate System

This is a contact method, where the pick-up error is detected when

the component to be detected touches the pick-up error confirmation

plate.

Notes: (a) When the component to be detected touches the pick-up

error confirmation plate and the actuator plate does not

return automatically, then return it manually.

(b) When the bulk feeder is used, replace the pick-up error

confirmation plate.

(Plate 7 mm shorter than the standard size)

Compared with standard plate use, the components to be

detected are limited.

Detection is available at anytime when the machine's power is switched

on ([POWER ON] button: Yellowish Green).

When using this specially designed machine, it is necessary to re-

place the upper cutter blade by flat type blade (9T).

(Such replacement is required because the L-shaped upper cutter blade

interferes with the detection unit).