00193732-02.pdf - 第54页

2 Retrofit Instructions for PCB Camera Multicolor, HS-50 / HS-60 SIPLACE HS- 50/HS-60 2.6 Changeover at Main Distribution Frame 11/2004 Edition 54 : Clip the universal illumina tion con verter board , relay K 1 and the t…

SIPLACE HS-50/HS-60 2 Retrofit Instructions for PCB Camera Multicolor, HS-50 / HS-60

11/2004 Edition 2.6 Changeover at Main Distribution Frame

: Detach all the remaining plug-in connectors for the camera illumination and power supply to

the SM motors.

: Remove the two boards from the top-hat rail.

: Detach the MATE-N-LOK plug-in connectors X24do / 9 and X31do / 6.

2.6.2 Fit the boards and relays, etc., and connect up the wiring

: For info, see also the circuit diagram Fig. 2.14.8 (= status after conversion).

Terminal 41 and 42

Power supply

to stepping motor

Relay K1

Illumination

converter

X24do

X31do

Catch clamp connector

2 Retrofit Instructions for PCB Camera Multicolor, HS-50 / HS-60 SIPLACE HS-50/HS-60

2.6 Changeover at Main Distribution Frame 11/2004 Edition

: Clip the universal illumination converter board, relay K1 and the two terminals 41 and 42 onto

the top-hat rail.

: Connect the terminals of plug connector X6dp (previously identified) at plug connector X6.

: Connect plug-in connectors X1 to X5 for the camera illumination and flash wire on the illumi-

nation converter.

: Replace each of the four AMP connectors for the power supplies to the stepping motors with

a blue ferrule (see picture).

: Now connect wire 00335250-xx (stepping motor) at X101 / 41b.

: Now connect wire 00335252-xx (stepping motor) at X101 / 41c.

: Now connect wire 00335254-xx (stepping motor) at X101 / 42a.

: Now connect wire 00335256-xx (stepping motor) at X101 / 42b.

: Insert the jumper (gray) in terminals 41/42.

: Connect cable W1 at X101 / 22a and X101 / 41a.

: Press the pin contact 9 of connector X24do (yellow) and socket contact 6 of connector X31do

(black) out of the housing.

Use the AMP extraction tool to do this.

This connection is not necessary any more.

: Press the socket contact of wire W2 into connector X31/6.

: Press the pin contact of wire W2 into connector X24/9.

: Connect the ferrule of wire W2 to terminal A1 of the relay.

: Connect terminal X7/2 to terminal 14 on the relay (W3).

: Connect terminal X7/1 to terminal 13 on the relay (W4).

: Connect terminal X6/6 to wire W5 with a twin ferrule and connect wire W5 at terminal A2 on

the relay.

SIPLACE HS-50/HS-60 2 Retrofit Instructions for PCB Camera Multicolor, HS-50 / HS-60

11/2004 Edition 2.6 Changeover at Main Distribution Frame

Hauptverteiler HS-50 / HS-60, Verdrahtung nach der Umrüstung 2