00198158-01_AI_Speed_Config_RV12_NC_EN.pdf - 第16页
Speed (Single-Sided) DLM-RV12 - Option 1 Installation Procedures 16 Assembly Instructions E by SIPLACE ► Place the "Reject Device" [03109608-xx] (1) onto the shim cover after the height has b een adjusted and s…
Speed (Single-Sided) DLM-RV12 - Option 1
Installation Procedures
Assembly Instructions E by SIPLACE 15
► Place the "Height measurement block SPEED" [03119428 xx] onto the shim cover and move the
head holder manually toward the block with care.
► Use a feeler gauge to determine the gap and the number of "NC shims" [03108395 xx] required.
► Place the required shims (1) underneath the shim cover and fasten them with an M3x8 countersunk
screw.
Speed (Single-Sided) DLM-RV12 - Option 1
Installation Procedures
16 Assembly Instructions E by SIPLACE
► Place the "Reject Device" [03109608-xx] (1) onto the shim cover after the height has been adjusted
and secure it with two M4x20 countersunk screws.
► Remove the red cover shown and locate the nozzle changer control cable [03102710
-
xx].
Speed (Single-Sided) DLM-RV12 - Option 1
Installation Procedures
Assembly Instructions E by SIPLACE 17
► Connect the cable [03102710
-
xx] to the cable of the nozzle changer "NC single row for DLM4 RV6/
12, C&P14 P" [03106322
-
xx].
► Mount the nozzle changer onto the shim covers on both ends and secure it with four M5x14 cap
screws.
► Assemble the active nozzle magazines.
► Remove the yellow covers shown.