Error Code List.pdf - 第13页

RL131 ERROR CODE LIST 2. ERROR COD ES DA8EEC-91-00 0-A0 2-2 DA8EEC-91-000-A0 2. ERROR CODES This chapter sum m arizes the error m essages, possible c ause of the err ors and counterm easures .

RL131

ERROR CODE LIST

2. ERROR CODES

DA8EEC-91-000-A0

2-1

2. ERROR CODES

RL131

ERROR CODE LIST

2. ERROR CODES

DA8EEC-91-000-A0

2-2

DA8EEC-91-000-A0

2. ERROR CODES

This chapter summarizes the error messages, possible cause of the errors and countermeasures.

RL131

ERROR CODE LIST

2.1 Self-diagnosis

DA8EEC-91-220-A0

2.1-1

2.1. Self-diagnosis

DA8EEC-91-220-A0

The RL131 performs self-diagnostic checks when power is turned ON. If any error message appears on the

Self-diagnosis screen, take appropriate action according to the following.

2.1.1 Self-diagnosis before Starting Operation

Error

code

Message Cause Solution

None Handle detection  The cam rotation handles has been

pushed in.

 Pull back the cam rotation handle.

 The right rail may have been lowered.  Return the right rail to the upper

position.

None Right rail traverse limit

 The sensor may be defective.  Check the condition of the sensor.

 The right rail may have been lowered.  Return the left rail to the upper position. None Left rail traverse limit

 The sensor may be defective.  Check the condition of the sensor.

None No M.ORG  The camshaft has been stooped at a

position other than the machine origin.

 Return the camshaft to the machine

origin.

None No NC data  NC data not selected in the production

setting.

 Select an NC data file from the

production setting menu.

None No Part data  Part data not selected in the production

setting.

 Select a part data file from the

production setting menu.

None No PCB data  Part data not selected in the production

setting.

 Select a PCB file from the production

setting menu.

None NC data contents abnormal  There may be invalid values in the NC

data.

 Check the contents of data on the NC

data edit screen.

None Parts data contents

abnormal

 There may be invalid values in the parts

data.

 Check the contents of data on the Parts

data edit screen.

None PCB data contents abnormal

 There may be invalid values in the PCB

data.

 Check the contents of data on the PCB

data edit screen.

None No insert step  There may be no insertion steps in the

selected NC data.

 Check the contents of the NC data.

 The transfer rail may be out of its return

limit.

 Check the return limit of the transfer

arm.

None No Loader origin

 The left/right rails may be out of their

return limits.

 Check the return limits of the left/right

rails.

None Transfer arm traverse limit  The transfer arm may have been

stopped at the traverse limit.

 Move the transfer arm to the return limit.

None H brake SW  The H brake switch has been set to the

Release position.

 Set the H brake switch to the Lock

position.

None H brake SW release OFF  Brake may have been applied with the

H-axis servo lock engaged.

 Release the H-axis brake.

None Thermal trip (dust collector)  Thermal trip may have been occurred on

the dust collector.

 Reset the thermal relay of the dust

collector.

None Feeder install error  The feeders may not have been installed

properly.

 Check the installation condition of the

feeders.

None Resistor abnormal  The resistor is abnormal.  Please wait until this error is reset.