00196056-0102 RI Shutterless 3x8 SL.pdf - 第37页

Replacing the Tape Duct Removing the Tape Duct Dismantling the Tape Duct Nachrüstanleitung / Retrofit Instructions F eeder Module 3x8 mm S 0201/0402 to Shutterless ( 3X8 mm SL) 37 X Carefully bend the top of the protecti…

Replacing the Tape Duct

Dismantling the Tape Duct Removing the Tape Duct

36 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to

7.1.3 Removing the Tape Duct

X Loosen the screws marked in the diagram (1–

3) on the right-hand side of the feeder.

X Loosen the screws marked in the diagram (1-

5) on the left-hand side of the feeder.

X Loosen the screw (1) on the top of the feeder.

X Disconnect the connector plug marked in the

diagram, from the lifting magnet.

NOTE:

Feeders of type 3x8mm S-tape for

0201/0402 components ("Golden

Feeder") do not feature this connector

plug.

Replacing the Tape Duct

Removing the Tape Duct Dismantling the Tape Duct

Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)

X Carefully bend the top of the protective cover

slightly forwards.

X Lift the tape duct first at the front and then tilt it

forwards and out of the feeder.

NOTE:

Take care not to lose the rubber foam

seal shown in the diagram.

You will need this seal again later on,

when you install the shutterless tape

duct.The seal prevents components

from falling down the back, into the

feeder and causing damage.

Replacing the Tape Duct

Dismantling the Tape Duct Loosening the Flaps

38 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to

7.1.4 Loosening the Flaps

X Loosen the screws marked in the diagram (1-

3), on the left and right of the tape duct.

X Lift the flaps off towards the front.