00198611-02_IM_712.1_R19-1_EN.pdf - 第51页

Station Software Version 7 12.1 (R19-1) / Installation Manual 05/2019 Edition 51 Before installing, you can check the available, required and recommended disk space (per driv e) to perform the installation. ► Click the D…

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

The Packages and Features dialog box is displayed.

Figure 5-38: Packages and Features

All available languages are enabled by default.

► If desired, unselect languages you do not want to install.

► Click the Next button.

The Language Pack is now ready to be installed. The following dialog box is displayed.

Figure 5-39: Ready for installation

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

Before installing, you can check the available, required and recommended disk space (per drive) to

perform the installation.

► Click the Disk Space button.

The Disk Space Requirements dialog box is displayed.

Figure 5-40: Disk Space Requirements

► Click the OK button.

The Ready to install dialog box is displayed again.

► Click the Install button to start the installation.

The setup status is displayed during installation.

Figure 5-41: Setup status

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

After successful installation, the following dialog is displayed.

Figure 5-42: Installation completed

► Click the OK button to exit the setup wizard.

When the installation has been completed, the language(s) you selected will be available on the

station software GUI and SIPLACE Vision GUI respectively.

NOTICE

Uninstalling the Language Pack

Please note that if you uninstall the Language Pack, all installed languages will be

uninstalled (Chinese included!). Single languages cannot be selected or deselected.

If Chinese shall be installed again, the standard Station Software installation must be

modified.

► Follow the instructions in section 8.1Fehler! Verweisquelle konnte nicht gefunden

werden..

► In the Features and Packages dialog, enable the Chinese language, too.