00198611-02_IM_712.1_R19-1_EN.pdf - 第9页

Station Software Version 7 12.1 (R19-1) / Installation Manual 05/2019 Edition 9 Automatic Calibration – System Identification for SX-Series The System identification calibration f eature has been introdu ced for the SX-s…

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

3 Upgrading to Station Software Version 712.x

This chapter describes which steps you generally must attend when upgrading to the current

station software version and which steps are additionally required when upgrading from lower to

higher software versions.

Upgrading from previous station software versions (701.x – 709.x) to station software version 712.x

is not possible due to a change in the installation technology beginning with station software

version 710.0.

If a previous station software version is already installed on the station computer, it will be

automatically uninstalled by the setup wizard before the current station software gets installed.

Only if the installation of station software 712.x fails, the previous station software version must be

manually uninstalled.

NOTICE

Individual machine data (calibration data) will not be deleted!

► Note some information before you start upgrading the station software.

During installation of station software 712.1 you will be asked for machine type, MID number

and serial number. These settings will not be transferred during upgrading (no default

settings!). You find this information on the GUI of your current station software version:

Figure 3-1: Example of machine information

► When upgrading the station software, always check the eSW versions and download the

current versions if necessary.

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

Automatic Calibration – System Identification for SX-Series

The System identification calibration feature has been introduced for the SX-series placement

machines in the automatic calibration. Therefore, an additional calibration step may be required

after installation. In this case, a warning is displayed that the calibration is not up to date. This also

applies for the respective station software version in compatible mode. Proceed as follows:

► Log in on the Machine service activity level.

► Switch to the Configure, update and calibrate machine menu.

► Press the Automatic calibration button.

The Automatic calibration wizard opens.

► Select All steps from the Select calibration steps list.

Figure 3-2: Calibration steps in Automatic calibration wizard

Station Software Version 712.1 (R19-1) / Installation Manual 05/2019 Edition

► Select the System identification calibration step.

Figure 3-3: System identification step