AG900+ and AG900+S Applicators Customer Product Manual.pdf - 第28页

AG − 900+ and AG900+S Applicators 24 Part 1098464A  2009 Nordson Corporation AG900+S Modules a. See Figure 1 1.Using two 5 / 16 in. open wrenches, loosen the needle from the cartridge rod. 2 1 Figure 1 1: Piston/Cartrid…

100%1 / 56
AG−900+ and AG900+S Applicators
23
2009 Nordson Corporation
Part 1098464A
AG900+/ Modules
a. See Figure 9. Loosen jam nut (3) on piston shaft and back nut up until against piston
shaft shoulder (4).
2
1
3
4
Figure 9: Piston/Cartridge Assembly and Needle Assembly
1. Piston/cartridge assembly
2. Needle assembly
3. Jam nut
4. Piston shaft shoulder
b. Unscrew old needle assembly from the piston/cartridge assembly.
NOTE: If piston assembly spins − put wrench on
wrench flats on top of piston.
c. See Figure 10. Remove o-rings and back-up ring from
piston/cartridge assembly.
Figure 10: Piston/Cartridge
Assembly and Needle
Assembly
1. Piston/Cartridge Assembly
2. Larger o-ring
3. Back-up ring
4. o-ring
1
2
4
3
AG−900+ and AG900+S Applicators
24
Part 1098464A
2009 Nordson Corporation
AG900+S Modules
a. See Figure 11.Using two
5
/
16
in. open wrenches, loosen the needle from the cartridge
rod.
2
1
Figure 11: Piston/Cartridge Assembly and Needle Assembly
1. Piston/cartridge assembly 2. Needle assembly
b. See Figure 10. Remove o-rings and back-up ring from piston/cartridge assembly.
AG−900+ and AG900+S Applicators
25
2009 Nordson Corporation
Part 1098464A
Assembly
1. Install new o-rings and back-up ring on
piston/cartridge assembly.
2. AG900+ Module: See Figure 12. Install the new
needle assembly onto the piston/cartridge
assembly. Turn until the needle bottoms out
against the end of the piston shaft.
AG900+S Module: See Figure 11. Install the new
needle assembly onto the piston/cartridge
assembly. Turn until the needle bottoms out
against the end of the piston shaft.
NOTE: If the piston shaft is not fully seated
inside the needle assembly, the piston/cartridge
assembly with the needle assembly will not
properly seat in the applicator module and
nozzle, resulting in adhesive leaking
.
Figure
12: Piston/Cartridge
Assembly and Needle
Assembly
1. Piston/cartridge assembly
2. Needle Assembly
3. Jam nut
3. AG900+ Module: Tighten jam nut.
AG900+S Module: Tighten the needle against the
cartridge rod using two
5
/
16
in. open end
wrenches.
4. Clean module bore.
5. Apply o-ring lubricant to the module bore inside the
module body.
CAUTION! Apply o-ring lubricant to module body bore ONLY. Lubricating o-rings
directly or individual components causes back-up rings to become dislodged
when module is assembled.
2
3
Bottomed
out against
Piston Shaft
1
AG900+