TRS Advanced WB Intel Issue 02.pdf - 第49页

Issue 2, Nov 14 TRS Advanced Maintenance 49 26. Power up the printer by turning the main is olator ON and pressing the green start button (RH side). 27. Enter diagnostics mode, when pr ompted to press the blue button. 28…

100%1 / 141
TRS Advanced Maintenance
48
Issue 2, Nov 14
19. [B] Disconnect the pneumatic pipes to each end of the LH TRA Cylinder.
20. [D] Re-fit the REAR Centre Rail Section onto its associated bearing carriage ensuring it
clears any MEK components.
21. [E] Tweak the Rear Rail position (using the Rail Width Drive Belts again) so that the
Board Clamp Plate is slightly rearward of the vacuum aperture in the MEK base.
22. [F] Fit the 215405 Rail Alignment Jig (RAJ) into the MEK base. Screw down (using 4x
700116 / 700603), making sure the Jig is located on the diamond reference pins & is fully
flat to the base.
23. Re-fit the front center rail section onto its associated bearing carriage.
24. Move the under screen cleaner to its home position at the front of the machine.
25. Carry out a visual collision check prior to re-connecting mains power and compressed air
services to the machine.
D
B
B
B
B
F
E
E
Issue 2, Nov 14
TRS Advanced Maintenance
49
26. Power up the printer by turning the main isolator ON and pressing the green start button
(RH side).
27. Enter diagnostics mode, when prompted to press the blue button.
28. Home the rising table.
29. Bring the rising table up to “vision height”.
30. Check that both front and rear rails are resting on the MEK and not on the clatter bars.
If required, adjust clatter bars equally to a lower height.
31. Power off the printer and disconnect mains power and compressed air.
TRS Advanced Maintenance
50
Issue 2, Nov 14
RAIL CAP FITTING:
32. Undo (but do not remove) the 6 off M5x16 cap head screws at the rear of the rail cap as
shown picture below.
33. Carefully fit the Rail Cap assembly over the rails and locate the guide rod clamps at the
rear of the Rail Cap over the guide rods.
34. Lightly shake the rail cap to locate the locating plates.