M3plus_OperationManual_e.pdf - 第59页
2 - 26 2 Basic oper ation 4. Starting and finishing production Monitor: Alignment The [Alignment] tab screen shows you the offset amount of each head calculated from the recognition results obtained during automatic oper…
2 -25
2
Basic operation
4. Starting and finishing production
"Edge Pos."
Displays a cross cursor at the lead or component edge position.
"Last Pos."
Displays a cross cursor at the center of the component.
Mark monitor mode
This specifies the monitor display mode during mark recognition. The recognition results and binary
image will appear on the image according to the selected item. This monitor mode can be changed
during operation.
"None"
Displays the image taken by the camera. The recognition result values are not displayed.
"Result"
Displays the center position coordinates (pixels) of the detected mark.
"Binary Image"
Displays the image taken by the camera as a binary image.
"Grey Image"
Displays the grey image after processing the image taken by the camera.
"Search Result"
Draws a line to make an approximate circle around the mark.
"Datum Circle"
Draws a mark of the specified diameter from the center of the detected mark. (Possible only in
specific recognition modes.)
"Tangent Circle"
Draws an inscribed circle and circumscribed circle from the center of the detected mark. (Possible
only in specific recognition modes.)
"Error Image"
Displays the error image. (Possible only in specific recognition modes.)
"Individual data"
Displays the individual data when multiple objects are detected. (Possible only in specific
recognition modes.)
[Img Check] button
Allows you to check and save the image that was recognized immediately before the machine
stopped during automatic operation. This function does not capture images continuously during
automatic operation.
2 -26
2
Basic operation
4. Starting and finishing production
Monitor: Alignment
The [Alignment] tab screen shows you the offset amount of each head calculated from the
recognition results obtained during automatic operation as well as error numbers.
Monitor: Alignment
27308-5E-20
Head No.
Shows the head No. used in the machine. The recognition results of the head No. used in the
sequence that starts from the current pickup are displayed. Note that the display is made after the
camera image recognition has completed.
Parts No.
Shows the number of the component picked up by the head and recognized with the camera.
Feeder Set No.
Shows the feeder set number of the component picked up by the head and recognized with the
camera.
X, Y, R
Displays the offset amount of each head calculated from the recognition results obtained during
automatic operation. This offset is the positional deviation from the center of the nozzle.
Error No.
Shows an error number when the head fails to make a recognition.
2 -27
2
Basic operation
4. Starting and finishing production
Monitor: Retry
The [Retry] tab screen displays the history for the past 100 errors.
Monitor: Retry
27309-5E-20
Monitor: Badmark
Badmark recognition results are shown on the [Badmark] tab during operation.
Shows badmark recognition results.
Badmark
Select badmark type. "Block No." selection box.
27314-5E-20