Operating Instructions_VF366_en.pdf - 第267页
6|Function description 6.17 Solder feed with turret bar container (option) Function This option is available exclusively for DIP soldering modules with induction pump. With the container it is possible to extend equipp…
6|Function description
Production using the soldering program
ü Production start:
ü An acceptable program has been chosen.
a) Run the soldering program.
ð If no flux type is specified in the program, production will start irrespective
of the type of flux in the tank.
b) If a flux material type has been specified in the soldering program, the control
system will check if the data in the [Flux unit 1 - mount data] setting dialog
match those of the soldering program.
ð If data do not coincide, the program will not run and a message will be dis-
played.
ð If data coincide, the program will run.
ð The process has now been completed.
Soldering report data
If you work with a program where a certain flux type is specified, these data will
also be recorded in the soldering report.
Low flux level in the tank
When the flux level is insufficient, a message will appear which shall be acknow-
ledged after flux refilling. If in the [Flux unit 1 - mount data] setting dialog you have
defined a flux material type, an additional message will appear. It prompts you to
specify the flux type in the setting window again. Only then you will be able to ac-
knowledge the message and continue operation. See the section Specifying flux
material type in the setting dialog [Flux unit 1- mount data].
Ersa GmbH Operating Instructions_VF366_en|Rev. 14|30/11/2017 266/551
6|Function description
6.17 Solder feed with turret bar container (option)
Function
This option is available exclusively for DIP soldering modules with induction pump.
With the container it is possible to extend equipping intervals, thanks to a solder
bar reserve of 7 pieces. The solder bars are placed in the turret container. The con-
trol system monitors the filling level of the container. If the level is low, the system
automatically feeds the entire solder bar.
Before starting operations, please read the For your safety [
}33] chapter and ob-
serve in particular its instructions on how to handle hot solder pots!
Container preparation and initial filling
This kind of maintenance work must be performed while the solder is liquid! There-
fore, the following safety instructions must be strictly followed:
DANGER
Severe or fatal injury from hot machine!
The entire machine is hot during operation and contains liquid metal!
a) Service on the hot machine may only be carried out by specially trained staff,
qualified for this type of work! For these types of work, a company internal oper-
ating procedure for protective clothing is to be issued!
b) You should always take into account the possibility for metal to spray out!
c) Special care is required when refilling the pot and working on the pot!
NOTE
Use suitable protective equipment!
When performing any work on a hot pot, protective clothing must be worn:
a) Safety shoes
b) Face protection
c) Heat resistant gloves
d) Heat resistant apron.
Ersa GmbH Operating Instructions_VF366_en|Rev. 14|30/11/2017 267/551
6|Function description
ü Filling the container:
ü The option has been set in the machine configuration.
ü You made sure that the solder bar and the solder pot have the same solder al-
loy.
ü The machine is in the operating mode [Maintenance mode] function.
ü A user logging into the system has respective rights.
a) Press the soldering module icon in the start dialog.
ð The [Soldering module] window appears.
b) In the [Switch functions] frame press the button to enable module mainten-
ance. When the module maintenance mode is active, this button turns yellow.
c) Open the hood on the soldering module.
Ersa GmbH Operating Instructions_VF366_en|Rev. 14|30/11/2017 268/551