00193730-04.pdf - 第31页
Retrofit instructions Splice Detection Basic Packa ge + Table Controller SIPLACE HF-series 08/2005 Edition 31 : Unscrew the four screws used to fix the tape reel cont ainer and remove the cont ainer . 2 2 : Position the …
Retrofit instructions Splice Detection Basic Package + Table Controller SIPLACE HF-series
08/2005 Edition
30
2.8 Adapter (third tape reel)
2.8.1 Content of retrofit kit (Part no.:00119642-01)
Qty Designation Part no.:
- 1 Left bracket, complete 03012611-01
- 1 Right bracket, complete 03012647-01
- Assembly materials
2.8.2 Installation
: Open the protective cover.
: Dock the component trolley out of the placement machine.
: Take the tape reels from the tape reel container.
: Take the outer tape separators (left and right) out of the component trolley.
2
2
2
2
2
2
2
Retrofit instructions Splice Detection Basic Package + Table Controller SIPLACE HF-series
08/2005 Edition
31
: Unscrew the four screws used to fix the tape reel container and remove the container.
2
2
: Position the brackets at right-angles to the partition and fix them loosely with two screws.
2
2
: Place the adapter (third tape reel) on the bracket and check the position with a spirit level.
Tighten the screws in the brackets if the adapter is straight.
2
2 screws
Hole in the bracket
Retrofit instructions Splice Detection Basic Package + Table Controller SIPLACE HF-series
08/2005 Edition
32
There is a hole in the front part of the bracket (see photograph above).
In the wall behind it, there may or may not be a hole with welding nut behind it, depending on which
component trolley is used. 2
: If there is a hole, then screw in a screw (M 6) to match the two others.
: If there is no hole, then drill a 6.2 mm diameter hole from the fitted bracket.
: Push a grooved dowel pin, external diameter 6.5 mm, into the drilled hole.
The grooved pin will thus be seated firmly.
: Fix the adapter with two screws on each side.
2
: Position the plain washers on the screw holes for the tape reel container.
2
If you fix the plain washers in place with adhesive tape, they will not slip when you position the
tape reel container. 2
2
2
: Refit the tape reel container, offset 110 mm forward.
: Insert the tape separators once more.
: Push the waste tape container beneath the component trolley.