00198171-02_Technical_Training_FSE_TX-Series_EN.pdf - 第47页
4 Gantry System Room for Your Sketches and Notes Technical Training FSE SIPLACE TX-Series 01/2018 47 Room for Your Sketches and Notes
4 Gantry System
4.9 Excercise: TX Gantry System
46 Technical Training FSE SIPLACE TX-Series 01/2018
Maintenance content Interval Equipment required
Compressed air filter Workflow 3 Air gun
Vacuum pump filter Workflow 3 Air gun, Allen key
Gas pressure shock absorber Workflow 4 Cleaning wipe
Linear guide bearing of X/Y Axis Workflow 4 Kluber oil BEM 34-132 cartridge
Protection covers Workflow 4 Cleaning fluid for the covers
Magnetic surfaces of X/Y Axis All workflows Cleaning wipe
4.9 Excercise: TX Gantry System
1. Which of the following is false regarding the TX Gantry system?
A The head interface board for Gantry 1 and 2 can be exchanged (swapped over).
B Both X and Y Axes are driven by linear motors.
C The TX gantry reference run is the same with X-Series S machine.
D MGCU is used for X and Y motor control.
2. Which action should be performed after exchange of the Y Axis encoder reader?
A Adjust the distance (0.75mm) between encode reader and scale.
B Calibrate travel range for both gantries.
C Calibrate machine zero point.
D All of the above.
3. Describe the machine reference run.
………………………………………………………………………………………………………
………………………………………………………………………………………………………
………………………………………………………………………………………………………
………………………………………………………………………………………………………
4 Gantry System
Room for Your Sketches and Notes
Technical Training FSE SIPLACE TX-Series 01/2018 47
Room for Your Sketches and Notes
4 Gantry System
Room for Your Sketches and Notes
48 Technical Training FSE SIPLACE TX-Series 01/2018