00198171-02_Technical_Training_FSE_TX-Series_EN.pdf - 第63页
6 Conveyor System 6.1 Main Overview Technical Training FSE SIPLACE TX-Series 01/2018 63 6 Conveyor System 6.1 Main Overview Main Overview TX ● As standard, the TX machines are set up with dual conveyors and fixed conveyo…
5 Component Supply
Room for Your Sketches and Notes
62 Technical Training FSE SIPLACE TX-Series 01/2018
6 Conveyor System
6.1 Main Overview
Technical Training FSE SIPLACE TX-Series 01/2018 63
6 Conveyor System
6.1 Main Overview
Main Overview TX
●
As standard, the TX machines are set up with dual conveyors and fixed conveyor on the outer
rail. The fixed conveyor left or right side is available as an option.
●
The whole conveyor consists of one part with input (410 mm), placement (PA, 380 mm) and
output (210 mm) sections.
●
The conveyor supports asynchronous and synchronous dual lane mode and I-Placement
mode
●
The conveyor supports the following heights: 900, 930 and 950 mm, standard height is 930
mm.
●
Communication between the PCB conveyors is provided with SMEMA or (optionally)
SIEMENS interface.
●
Input and output conveyor extensions (for barcode scanner, JTF-ML feeder).
1. Transport control board (box)
2. Transport drives
3. Width adjustment motor
4. Lifting table (below lifting motor)
5. Output section (219mm)
6. Placement Area (380mm)
7. Input section (410mm)
T. Transport direction
Conveyor Modes
1. Dual conveyor as single
mode (License required)
2. Synchronous mode op-
tional second sensor in PA
3. Asynchronous mode
with optional second
sensor in PA
NOTICE
If the length of boards is shorter than 175mm, an additional optional light barrier sensor can
be installed for the "Convoy Mode".
Main Overview TX micron
In order to ensure the required accuracy the TX micron conveyor system is slightly different to the
standard TX machine.
6 Conveyor System
6.2 Specification
64 Technical Training FSE SIPLACE TX-Series 01/2018
T - Transport direction
1. Fixture of additional fiducial bar to machine
frame
2. Fixture rail on the vacuum tool in Y direc-
tion
3. Additional fiducial bar for lane 2 in X direc-
tion
4. Vacuum tool on lane 2
5. Additional fiducial bar for lane 1 in X direc-
tion
6. Vacuum tool on lane 1
TX micron vacuum tooling
Vacuum tooling SIPLACE TX micron 15µm with Y-fiducial bar. This vacuum tool is necessary to
ensure the accuracy on customer side with the new ACT board (100x250mm).
1. X-fiducial bar
2. Vacuum tooling location
3. Y-fiducial bars
The TX micron machines will be equipped with two X-fiducial bars parallel to the conveyor close
outside of the conveyor rails on the standard conveyor.
1. Two X-fiducial bars used for increased ac-
curacy during placement process.
6.2 Specification
Extract conveyor specification for TX
Dual conveyor standard (L X W) 50 x 45mm to 375mm x 260mm
Dual conveyor single lane mode (L X W) 50 x 45mm to 375mm x 460mm
Standard PCB thickness 0.3 mm to 4.5mm
Maximum PCB weight 2 kg
Clearance below PCB 25 mm
Maximum PCB warpage 2 mm