FUJI CP6 Bulk F3.0 Feeder手册.pdf.pdf - 第19页

3. Reattach the outer pipe. • Attach the outer pipe, taking care that the springs are attached at the correct positions. As shown in the following figure, the spring with the denser pitch should be attached at the lower …

Reassembly

• Follow the instructions below to replace the parts that were removed during the

foregoing cleaning procedure.

• Perform the following procedure exactly as described to prevent unintended

alteration of the feeder’s pickup position.

1. Reattach the inner pipe.

• Replace the inner pipe if it has been removed, taking care to orient it correctly. The

pipe end with the larger inner diameter should be on top, so it can be connected to

the hopper; the end with the smaller inner diameter connects to the chute channel.

Insert the pipe all the way, leaving no gap between the inner pipe and the chute

channel.

2. Reattach the pipe retainer.

• Attach the pipe retainer so that it is flush against the reference surface and the

bottom edge is flush with the bottom edge of the feeder.

BF009

Flush with bottom edge of feeder.

Flush against reference surface.

Pipe retainer

Large inner diameter

Small inner diameter

Upper end

Lower end

CORRECT

PIPE

ORIENTATION

BF008

Chute channel

Inner pipe

Insert until flush

Connects to hopper

Cleaning and Lubrication

Version 3.0 6 CP-6 Bulk Feeder Instruction

3. Reattach the outer pipe.

• Attach the outer pipe, taking care that the springs are attached at the correct

positions. As shown in the following figure, the spring with the denser pitch

should be attached at the lower end of the pipe, and the spring with the wider

pitch at the upper end.

4. Reattach the rear belt cover.

• Attach the rear belt cover, making sure it is flush against both the protruding edge

on the feeder arm and the front of the chute block.

5. Reattach the hopper.

• Reinsert the bushing in the bottom of the hopper, then attach the hopper to the

feeder by fitting the bushing over the outer pipe.

• Adjust the position of the hopper so it sits squarely on the feeder.

• After attaching the hopper, make sure the outer pipe rises and falls smoothly

when the lever is operated.

Operate lever manually and make sure

the outer pipe rises and falls smoothly.

BF012

Chip feeder direction

Flush against protruding edge.

BF01

Flush against chute bloc

Wider pitch

Denser pitch

BF010

Cleaning and Lubrication

Version 3.0 7 CP-6 Bulk Feeder Instruction

6. Reattach the guide (pickup area cover).

• Attach the guide, making sure that it is flush against the protruding edges on the

feeder arm as shown in the figure below.

7. Reattach the front belt cover.

• Insert the front belt cover horizontally between the guide attached in the previous

step and the rear belt cover attached in step 4. Secure the front belt cover, making

sure there is no gap between it and the feeder arm. Also make sure there is no gap

between the front belt cover and the either the guide or the rear belt cover.

8. Reattach the stainless steel plate.

• Attach the stainless steel plate to the side of the feeder, securing it with the original

seven bolts.

Guide

Rear belt cover

Front belt cover

BF014

Flush against protruding edge.

BF013

Cleaning and Lubrication

Version 3.0 8 CP-6 Bulk Feeder Instruction