cp842_eng_spec.pdf.pdf - 第6页

Prelim inar y CP-842E/ 842 ME S p ecif icati ons - 4 - 3. Machine Specifications 3.1 Per formance Specifications Specifi cations Item CP-842E CP-842M E Part size 0603 (020 1) (040 2 (01005) ) to 19 × 19 mm Parts *1 Part …

Preliminary CP-842E/842ME Specifications- 3 -

Notes:

1. Power Source: The built-in transformer has primary side taps of 200, 210, 220, 230,

380, 400, 415, 460 and 480 Volts. A dedicated power source, not shared with other

large equipment, should be used to avoid problems with electrical noise, voltage

fluctuations, and high frequency distortions.

2. No condensation

3. IP22: IEC protection against intrusion by body parts, and water.

Preliminary CP-842E/842ME Specifications- 4 -

3. Machine Specifications

3.1 Performance Specifications

Specifications

Item

CP-842E CP-842ME

Part size 0603 (0201) (0402 (01005)) to 19 × 19 mmParts

Part height Up to 6 mm

Tape size

8, 12, 16, 24, 32 mm

(7”, 13”, 15”)

Packaging

Bulk case 1005C (0402C), 1608C (0603C)

Capacity 70 × 2 40 × 2

100 % Cam speed 0.068 sec./part

X, Y axis 14.2 mm (including compensation

Z-axis 1.09 mm

D-axis None

θ-axis No limit

NC-axis Within one pitch

Placing rate

Max.

movement

NY-axis 0.8 mm

Placing accuracy

Rectangular chips, etc.

Currently undergoing testing

Placing reliability 99.99 % (including automatic recovery)

Fiducial mark reading time

Approximately 0.25 sec./mark

Warranty period

Warranty period for the equipment is 6,000 working

hours or 2 years (whichever elapses first).

Warranty period for the control software is 2,000

working hours or 1 year (whichever elapses first).

Warranty period for the feeders is 1 year.

Notes:

1. Support for placing 0402 (01005) parts is optional.

2. JIS, EIAJ compliant tape parts and EIA tape parts that are the same as EIAJ standard

parts.

3. The placing rate is reduced to 0.098 sec./part for one pitch movement of the D-axis, to

0.08 sec./part for two pitch movement of the NC-axis, and to 0.09 sec./part for three

pitch movement of the NC-axis.

4. The placing accuracy is obtained using fiducial mark referencing, based on tests

conducted by Fuji. Parts rotational offset is not considered. The above mentioned

Preliminary CP-842E/842ME Specifications- 5 -

accuracy may not be attained if the fabrication accuracy of the PCB or the parts that are

placed is not sufficient.

5. The fiducial mark reading time is obtained when reading a 1.2 mm diameter mark,

excluding the time to required to travel from mark to mark, and to make adjustments for

mark shape variations and location errors.

6. Some specified feeder parts, including consumable parts such as tape leaf and take-up

reel, are excluded from warranty. The feeder warranty period for overseas-users is

expanded to fourteen months from the date of factory shipment.