00198168-02_Technical_Training_TX-Series_EN.pdf - 第168页
6 Component Supply Room for Your Sketches and Notes 168 Technical Training SIPLACE TX-Series 10/2016
6 Component Supply
Room for Your Sketches and Notes
Technical Training SIPLACE TX-Series 10/2016 167
6 Component Supply
Room for Your Sketches and Notes
168 Technical Training SIPLACE TX-Series 10/2016
7 Conveyor System
7.1 Main Overview
Technical Training SIPLACE TX-Series 10/2016 169
7 Conveyor System
7.1 Main Overview
Main Overview TX
●
As standard, the TX machines are set up with dual conveyors and fixed conveyor on the outer
rail. The fixed conveyor left or right side is available as an option.
●
The whole conveyor consists of one part with input (410 mm), placement (PA, 380 mm) and
output (210 mm) sections.
●
The conveyor supports asynchronous and synchronous dual lane mode and I-Placement
mode
●
The conveyor supports the following heights: 900, 930 and 950 mm, standard height is 930
mm.
●
Communication between the PCB conveyors is provided with SMEMA or (optionally)
SIEMENS interface.
●
Input and output conveyor extensions (for barcode scanner, JTF-ML feeder).
1. Transport control board (box)
2. Transport drives
3. Width adjustment motor
4. Lifting table (below lifting motor)
5. Output section (219mm)
6. Placement Area (380mm)
7. Input section (410mm)
T. Transport direction
Conveyor Modes
1. Dual conveyor as single
mode (License required)
2. Synchronous mode op-
tional second sensor in PA
3. Asynchronous mode
with optional second
sensor in PA
NOTICE
If the length of boards is shorter than 175mm, an additional optional light barrier sensor can
be installed for the "Convoy Mode".