00198168-02_Technical_Training_TX-Series_EN.pdf - 第169页
7 Conveyor System 7.1 Main Overview Technical Training SIPLACE TX-Series 10/2016 169 7 Conveyor System 7.1 Main Overview Main Overview TX ● As standard, the TX machines are set up with dual conveyors and fixed conveyor o…
6 Component Supply
Room for Your Sketches and Notes
168 Technical Training SIPLACE TX-Series 10/2016
7 Conveyor System
7.1 Main Overview
Technical Training SIPLACE TX-Series 10/2016 169
7 Conveyor System
7.1 Main Overview
Main Overview TX
●
As standard, the TX machines are set up with dual conveyors and fixed conveyor on the outer
rail. The fixed conveyor left or right side is available as an option.
●
The whole conveyor consists of one part with input (410 mm), placement (PA, 380 mm) and
output (210 mm) sections.
●
The conveyor supports asynchronous and synchronous dual lane mode and I-Placement
mode
●
The conveyor supports the following heights: 900, 930 and 950 mm, standard height is 930
mm.
●
Communication between the PCB conveyors is provided with SMEMA or (optionally)
SIEMENS interface.
●
Input and output conveyor extensions (for barcode scanner, JTF-ML feeder).
1. Transport control board (box)
2. Transport drives
3. Width adjustment motor
4. Lifting table (below lifting motor)
5. Output section (219mm)
6. Placement Area (380mm)
7. Input section (410mm)
T. Transport direction
Conveyor Modes
1. Dual conveyor as single
mode (License required)
2. Synchronous mode op-
tional second sensor in PA
3. Asynchronous mode
with optional second
sensor in PA
NOTICE
If the length of boards is shorter than 175mm, an additional optional light barrier sensor can
be installed for the "Convoy Mode".
7 Conveyor System
7.1 Main Overview
170 Technical Training SIPLACE TX-Series 10/2016
Main Overview TX micron
In order to ensure the required accuracy the TX micron conveyor system is slightly different to the
standard TX machine.
T - Transport direction
1. Fixture of additional fiducial bar to machine
frame
2. Fixture rail on the vacuum tool in
Y direction
3. Additional fiducial bar for lane 2 in
X direction
4. Vacuum tool on lane 2
5. Additional fiducial bar for lane 1 in
X direction
6. Vacuum tool on lane 1
TX micron vacuum tooling
Vacuum tooling SIPLACE TX micron 15µm with Y-fiducial bar. This vacuum tool is necessary to
ensure the accuracy on customer side with the new ACT board (100x250mm).
1. X-fiducial bar
2. Vacuum tooling location
3. Y-fiducial bars
The TX micron machines will be equipped with two X-fiducial bars parallel to the conveyor close
outside of the conveyor rails on the standard conveyor.
1. Two X-fiducial bars used for increased
accuracy during placement process.