Covers.pdf - 第25页

COVERS MACHINE COVERS Chapter Issue 2 Sep 09 Technical Reference Manu al 3.25 NOTE T o refit the contact assembly to the switch body , using the locating keyway , push the two units together until the y click into place.…

100%1 / 28
COVERS
MACHINE COVERS
3.24 Technical Reference Manual Chapter Issue 2 Sep 09
Front Corner Panels To remove the front corner panels, carry out the following:
1. Open the front printhead cover.
2. Remove the front panel (as detailed previously).
3. Remove the corresponding safety cover (as detailed previously).
NOTE
Before a front corner panel can be removed, the control switches (jog switch
and system switch or jog switch and E Stop) must be disconnected.
4. To disconnect the system switch and jog buttons carry out the following:
a. Locate the two release slots in the contact assembly part of the switch.
b. Insert the switch release tool (Part No. 188647) into the slots and push
until the release tool clicks into place.
c. Leaving the switch release tool in position, pull the contact assembly from
the switch body.
d. Remove the switch release tool from the contact assembly.
COVERS
MACHINE COVERS
Chapter Issue 2 Sep 09 Technical Reference Manual 3.25
NOTE
To refit the contact assembly to the switch body, using the locating
keyway, push the two units together until they click into place.
5. To disconnect the E Stop carry out the following:
a. Remove the contact assembly part of the E Stop by turning the latch anti-
clockwise.
6. Remove the appropriate M5 cap head screw (refer to rear corner panels
figure for screw position).
7. Lift the panel clear of the machine.
8. Repeat Steps 3 to 7 for the other front corner panel, if required.
Lower Side Panels To remove the lower side panels, carry out the following:
1. Remove the corresponding safety cover (as detailed previously).
2. Open the front printhead cover.
3. Remove the front panel (as detailed previously).
4. Remove the rear panel (as detailed previously).
5. Remove the rear fixed printhead cover (as detailed previously).
6. Remove the corresponding rear corner panel (as detailed previously).
7. Remove the corresponding front corner panel (as detailed previously).
COVERS
MACHINE COVERS
3.26 Technical Reference Manual Chapter Issue 2 Sep 09
8. Remove the two M5 cap head screws.
9. Tilt the top of the panel away from the machine and lift the panel clear.
10. Repeat Steps 1 and 6 to 9 for the other lower side panel, if required.
Upper Side Panels To remove the upper side panels, carry out the following:
1. Remove the corresponding safety cover (as detailed previously).
2. Open the front printhead cover.
3. Remove the front panel (as detailed previously).
4. Remove the rear panel (as detailed previously).
5. Remove the rear fixed printhead cover (as detailed previously).
6. Remove the corresponding rear corner panel (as detailed previously).
7. Remove the corresponding front corner panel (as detailed previously).
8. Remove the four M5 cap head screws.
9. Tilt the bottom of the panel away from the machine and lift the panel clear.
10. Repeat Steps 1 and 6 to 9 for the other upper side panel, if required.
View on Left Hand Side of Machine
M5 Cap Head
Screws
View on Left Hand Side of Machine
M5 Cap Head Screws
M5 Cap Head Screws