Covers.pdf - 第8页
COVERS MACHINE COVERS 3.8 Technical Reference Manual Chapter Issue 2 Sep 09 Sliding Glass Cover Machine T ype iX In order to protect personn el and prevent damage to the machine, ten covers are fitted to the machine. The…
COVERS
MACHINE COVERS
Chapter Issue 2 Sep 09 Technical Reference Manual 3.7
Rear Corner Panels To remove the rear corner panels, carry out the following:
1. Remove the corresponding upper side panel (as detailed previously).
2. Release the quarter-turn fastener that secures the corner panel.
3. Lift the corner panel upwards to disconnect the panel from the side panel
and the guide pins that locate the panel to the machine frame.
4. Repeat Steps 1 to 3 for the other corner panel, if required.
Side Panels To remove the side panels, carry out the following:
1. Remove both corresponding corner panels (as detailed previously).
2. Using a cross head screwdriver, release the two fasteners that secure the
side panel to the cover frame.
3. Lift the side panel upwards to clear the two guide pins that locate the panel
to the machine frame.
Rear Corner
Panel Quarter-
Turn Fastener
Rear Corner
Panel Quarter-
Turn Fastener
Side Panel Securing Fasteners
View on Right Hand Side of Machine
Cover Frame
Main Frame
COVERS
MACHINE COVERS
3.8 Technical Reference Manual Chapter Issue 2 Sep 09
Sliding Glass
Cover Machine
Type iX
In order to protect personnel and prevent damage to the machine, ten covers
are fitted to the machine.
The sliding glass cover, the rear printhead cover and two upper side panels
which house the control switches protect the upper part of the machine. The
four corner panels, front and rear panels, safety covers and the front and rear
side panels protect the lower part of the machine.
Figure 3-4 Sliding Glass Cover Type iX
NOTE
Some of the covers can only be removed in a specific order due to the covers
interlocking with each other.
Item Description Item Description
1 Sliding Glass Cover 7 Safety Cover (2 positions)
2 Right Hand Upper Side Panel 8 Rear Corner Panel (2 positions)
3 Front Corner Panel (2 positions) 9 Left Hand Upper Side Panel
4 Front Panel 10 Rear Panel
5 Front Side Panel (2 positions) 11 Rear Printhead Cover
6 Rear Side Panel (2 positions)
1
2
3
4
5
6
9
11
10
8
Front Left Quarter View
7
COVERS
MACHINE COVERS
Chapter Issue 2 Sep 09 Technical Reference Manual 3.9
Cover Removal Before removing covers ensure that the supplies (air and electrical) have been
isolated from the machine.
Quarter-Turn Ring
Fasteners
To remove a panel secured with quarter-turn ring fasteners, turn the fastener
ring anti-clockwise (-) by a quarter-turn and pull out. To refit a panel, locate the
fastener shaft into the fastener, push against the spring whilst turning the ring
clockwise a quarter turn to secure (+).
Figure 3-5 Quarter-Turn Ring Fastener
Figure 3-6 Fastener Locations
+
-
Locations (behind panels) of the Quarter Turn Ring Fasteners