N7201A653E.pdf - 第277页
NPM- TT2 EJM1EE-MB -12M-04 12-2 -3 Consumable parts replacement Check the PCB transfer (→[Operating Procedure] P.5-2-8) Unlock the machine and ON 12 13
NPM-TT2 EJM1EE-MB-12M-04
Replacing the transfer belt
of the extension conveyor
(Option) 2
12-2-2
Maintenance
12-2
8
Hook a new belt
Belt length [mm] Product No.
1573 N510062788AA
● Loosen screws of the tension pulley in advance. (one on each)
■2 belts on each lane
Lane 1
Tension pulley
●About the front and rear sides of the belt
Front side: No letter printed
Rear side: Letters are printed
●Install the belt so the belt front side shall be the PCB transfer side.
Lane 2
Adjust the belt
tension
(→P.6-5)
●Two
Screws:
M4
Attach the
feeder table
cover (→P.3-3)
Tension pulley
Attach the tray
feeder or the
feeder cart
●For a tray feeder
(→ P.14-8)
●For a feeder cart
(→ P.3-2)
9
10
11
NPM-TT2 EJM1EE-MB-12M-04
12-2-3
Consumable parts
replacement
Check the PCB
transfer
(→[Operating Procedure]
P.5-2-8)
Unlock the
machine and
ON
12
13
NPM-TT2 EJM1EE-MB-12M-04
Replacing the
batteries 1
12-3-1
Maintenance
12-3
Describes the procedure for replacing the batteries.
●If the battery voltage decreases, a warning message is displayed on the monitor, or the LED indicator lamp
goes out. Replace the batteries with new ones according to the procedure.
●The FA PC model may look different than the images used in this manual. Perform operation or
maintenance based on your FA PC model.
●Batteries are used for multiple parts including the control board of the machine. Used batteries should be
disposed of in compliance with the laws or regulations of each country, or contact your local government or
the service agency from which you purchased them.
●Mishandling the batteries could lead to an accidents including leakage, heat generation, explosion or
ignition, or malfunction of equipment. Be sure to observe the following.
・In case battery liquid gets into eyes, wash eyes with plenty of clean water such as tap water. Get
medical attention immediately.
・Do not charge the battery.
・Do not short (+) and (-) of the battery, or do not insert in reverse.
・Do not throw into a fire, heat, disassemble or remodel the battery.
・Do not deform the battery or apply strong impact.
・Immediately remove the drained battery from the device.
●Because the control PCB may break due to static electricity, be careful of handling with using earth band.
●Avoid the control PCB Short-circuiting by putting it directly on the metal surface. It does not cause smoke
or ignition but it may decrease battery life after being replaced.
NOTICE