Autosite_Users_Manual.pdf - 第38页
Setup and Ins tallation 2-16 Auto Site Us er Man ual 7. Insert a flat blade screwdriver into the no tch shown in Figure 2-1 4. Disconnect th e bottom of the air shock by twi sting the blade of the screwdriver and pulling…
Setup and Installation
AutoSite User Manual 2-15
Figure 2-13
Lowering the Programmer Shelf
PROGRAMMING STATION
1407-1
KNOB
PROGRAMMER SHELF
Setup and Installation
2-16 AutoSite User Manual
7. Insert a flat blade screwdriver into the notch shown in Figure 2-14.
Disconnect the bottom of the air shock by twisting the blade of the
screwdriver and pulling the bottom of the air shock toward you.
8. Loosen the knob on the programmer shelf and push the programmer
shelf to its bottom-most position.
9. Using a 5/64-inch hex driver, remove the three hex head screws on
the right side of the back of the programmer shelf. Discard these
screws; you will not need them later.
Note: When you remove the last of the three screws, the shelf guide and air shock
assembly will slide off the track.
10. After you have removed all three screws, remove the shelf guide
from the track. Set the shelf guide and the air shock aside; you will
need them later.
11. Remove the knob and shaft from the programmer shelf by turning
the knob counterclockwise. Discard the knob and shaft; you will not
need them later.
Figure 2-14
Disconnecting the Air Shock
1408-2
TRACK
AIR SHOCK
ASSEMBLY
NOTCH
PROGRAMMER
SHELF
SCREW DRIVER
Setup and Installation
AutoSite User Manual 2-17
12. Using a 5/32-inch hex driver, remove the eight hex head screws on
the left side of the programmer shelf. Set these screws aside; you will
need them later.
Note: Support the shelf before you remove the last few screws. The shelf will fall
from the 3000 when you remove the last screw.
13. After you have removed all eight screws, remove the programmer
shelf and discard it. You will no longer need the programmer shelf.
Reroute the Optics
Follow the steps below to reroute the optics on the 3000 (or 7000):
1. Locate the two optics shown in Figure 2-15.
2. Working with one optic at a time, follow the steps below:
a. Trace the optic wire back to its connector.
b. Disconnect the connector.
c. Feed the optic wire back through the hole so the optic wire is
above the programming track.
d. Feed the optic wire down through the new opening.
e. Reconnect the optic wire to the connector.
Note: You may have to cut a cable tie to free up enough of the optic wire to allow
you to reroute the optic through the new opening.
3. Repeat the procedure described in step 2 with the other optic shown
in Figure 2-15.
4. Using a cable tie, secure the rerouted optic wires to an adjacent wire
bundle.
Figure 2-15
Rerouting Two Optics
OPTIC 1
1409-1
OPTIC 2
PROGRAMMING STATION