00197674-01-UM-E-Series-EN-02-2015.pdf - 第187页
User manual SIPLACE E 4 Setting up and commissioning From software version SC 708.0 12/2014 Edition 4.3 Setting up th e machine 187 4.3.6.1 Conveyor height 950 (Option) Item no. 03111069-xx Conveyor hei ght 950 block 4 F…
4 Setting up and commissioning User manual SIPLACE E
4.3 Setting up the machine From software version SC 708.0 12/2014 Edition
186
Loosen the locking screw (2). This locking screw fixes the machine feet (3) and prevents it
falling down as soon as the clamp has been loosened.
Loosen the three clamping screws (5) on the adapter (6).
Loosen the other three machine feets (3) in the same manner.
Use the 30 mm spanner to adjust the height of each machine feet (3) at the setting screw (1),
so that the relevant conveyor height is achieved.
Align the machine in the X and Y direction with the machine spirit level.
4
Tighten the clamping screws (5) of each machine feet to a torque of 130 Nm.
Tighten the locking screws (2) of each machine feet.
PLEASE NOTE
For a description of how to align the machine in the X and Y directions, refer to the section
4.3.7
, page 189.
User manual SIPLACE E 4 Setting up and commissioning
From software version SC 708.0 12/2014 Edition 4.3 Setting up the machine
187
4.3.6.1 Conveyor height 950 (Option)
Item no. 03111069-xx Conveyor height 950 block
4
Fig. 4.3 - 3 Conveyor height 950 block
(1) Block
(2) Bracket
(1)
(2)
4 Setting up and commissioning User manual SIPLACE E
4.3 Setting up the machine From software version SC 708.0 12/2014 Edition
188
4
Fig. 4.3 - 4 Machine feet on conveyor height 950 block
(1) Conveyor height 950 block
(2) Bracket for additional securing to the machine floor
(3) Machine feet
4
Push the forks of the pallet jack under the machine. See also 4.3.2, on page 182.
With the pallet jack, raise the machine.
Place the four blocks (1) below the four machine feet.
With the pallet jack carefully lower the machine.
Align the machine feet within the circular step of these blocks and place the machine onto
these blocks (1).
Align the machine in the X and Y direction with the machine spirit level.
4
Secure the block with the bracket to the machine floor if necessary.
WARNING
Risk of injuries!
There is a risk of injury during assembly work to the underside of the machine!
Secure the machine using suitable measures. The pallet jack must not be used as
the only support.
Take care that your hands and feet can not be hit.
PLEASE NOTE
For a description of how to align the machine in the X and Y directions, refer to the section
4.3.7
, page 189.
(1)
(3)
(2)