00197674-01-UM-E-Series-EN-02-2015.pdf - 第236页
5 Working with the machine User manual SIPLACE E 5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition 236 Step2 5 5 Fig. 5.11 - 5 Pickup window on the feeder module (1) Tape support, removabl…
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.11 Setting up the feeder modules
235
5.11.4.3 Inserting the tape into the SIPLACE SmartFeeder E
Step1 5
5
Fig. 5.11 - 4 Inserting the component tape
(1) Entry to the tape guide channel
(2) Tape guide channel outlet
Hold the component tape so that the transport holes are on the left-hand side viewed in the
direction of travel.
Push the component tape into the entry (item 1) to the tape guide channel and further until it
emerges from the exit opening (item 2).
Pull the component tape up and out.
(1)
(2)
5 Working with the machine User manual SIPLACE E
5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition
236
Step2 5
5
Fig. 5.11 - 5 Pickup window on the feeder module
(1) Tape support, removable (see section 5.11.4.4, page 238)
(2) Pickup window
(3) Removal edge for the cover foil
(4) Component pickup area
(5) Lever for raising and latching the pick-up window
Guide the start of the tape beneath the pickup window (item 2) and further until the compo-
nent tape is touching the sprocket wheel.
On the operator panel, press the FORWARD button until the bend of the cover foil is in the
component pickup area (item 4).
Push the lever (item 5) forward in order to raise the pickup window (item 2) into the first latch-
ing position.
Pull the cover foil at the side of the pick-up window forward and out.
Fold the cover foil back until it lies against the removal edge (item 3).
5
Push the lever (item 5) back to lower the pickup window.
PLEASE NOTE
Do not lower the pick-up window until the cover foil is lying against the pull-off edge.
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.11 Setting up the feeder modules
237
Step3 5
5
Fig. 5.11 - 6 Guiding the cover foil to the foil packing wheels
(1) Cover foil packing wheels
(2) Cover foil rocker
5
Guide the cover foil over the cover foil rocker (item 2) until it reaches the foil packing wheels
(item 1).
On the operator panel, press the FOIL button until the cover foil is tensioned. The cover foil
rocker points down and stops the drive motor.
Cut the component tape flush with the front end of the feeder module.