00197674-01-UM-E-Series-EN-02-2015.pdf - 第224页
5 Working with the machine User manual SIPLACE E 5.9 Shift changeover From software version SC 708.0 12/2014 Edit ion 224 5.9.2 Safety instructions for em ptying the waste tape container 5 Fig. 5.9 - 1 Safety instruction…
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.9 Shift changeover
223
5.9 Shift changeover
5.9.1 Shift changeover tasks
Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift
starts. This minimizes extended down times.
At the shift change, pass important information on to the next operator. This includes, for in-
stance, changes to the placement program. Also read through the list of the descriptions of
the steps to take in section 5.13, page 242.
Carry out a setup check.
Make sure that the feeder modules are equipped with the correct components, that they are
at the correct locations in the changeover table and that the conveyor increment is set cor-
rectly.
Clean the following line assemblies:
Empty the reject bin and carefully vacuum the area around the reject bin.
Carefully vacuum the nozzle changer, feeder modules and the changeover table.
Empty the waste tape container. Follow the safety instructions given in section 5.9.2, page
224.
Empty the tray for the machine cover.
5 Working with the machine User manual SIPLACE E
5.9 Shift changeover From software version SC 708.0 12/2014 Edition
224
5.9.2 Safety instructions for emptying the waste tape container
5
Fig. 5.9 - 1 Safety instructions for emptying the waste tape container
(1) Handle
(2) Waste tape container
The waste tape container must be pulled out of the changeover table for emptying. There is a risk
of catching your fingers as you do so.
To avoid this risk, hold the waste tape container with your fingers in the handle
(item 1).
Do NOT put your fingers in the gap between the tape container and waste tape container as
you could catch your fingers if you do.
(1)
(2)
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.10 Carrying out a sight check
225
5.10 Carrying out a sight check
5.10.1 Checking the SIPLACE SmartFeeder E
5
Fig. 5.10 - 1 Checking the SIPLACE SmartFeeder E (example of 8 mm E shown)
(1) Flap
(2) Blade
(3) Status display
(4) LED display
5
Check to see whether the tape foil removal container for the SIPLACE SmartFeeder E is full.
Open the flap (item 1). Pull out the cover foil and cut it with scissors or on the integral blade
(item 2) on 8 and 12 mm SIPLACE SmartFeeder E.
5
(1)
(2)
(3)
(4)