00192368-01.pdf - 第47页
Retrofit Instructions / User Manual Vacuum Tooling for HS-50 Edition 12/00 8 Spare Parts 47 6S DUH 3D UW V 1 Soleno id valv e, Art. No. 003 09936-01 1 Silen cer, Art. No. 00 047900-0 1 1 Ventur i nozzle, A rt. No. 003…
Vacuum Tooling for HS-50 Retrofit Instructions / User Manual
7 Troubleshooting Edition 12/00
46
this work by Siemens (section 4).
- Some other electrical interruption -> Notify Siemens SMD Service.
±
PCB is not being sucked against suction cup correctly:
– Vacuum plate (top plate of tool) and/or suction cups are not clean / Components may be
lying around -> Perform maintenance (Section 9).
– Required vacuum branches are switched off and/or branches which are not necessary are
switched on (depending on the version: see Fig. 3 - 1) -> In instances where manual shut-
off cocks are adapted to PCB length, open/close the appropriate branch -> In instances
where automatic shut-off valves are involved, check the function of the valve and exchange
it if necessary.
– Several suction cups are not completely covered -> No air present (see Section 5).
– Vacuum branch(es) not sealed -> Tighten screw connections (including those on bottom of
the top plate).
– Option placed incorrectly -> PCB against stopper must be drawn against the the suction
cups optimally by vacuum.
'DPDJHWR3&%ZKLOHORZHULQJWKH/LIWLQJ7DEOH
±
Vacuum is not reduced / not reduced in time
– Time interval set for “Reduce vacuum” is too short -> Setting to made only by persons who
have been especially trained for this by Siemens (see Section 5).
Retrofit Instructions / User Manual Vacuum Tooling for HS-50
Edition 12/00 8 Spare Parts
47
6SDUH 3D UWV
1 Solenoid valve, Art. No. 00309936-01
1 Silencer, Art. No. 00047900-01
1 Venturi nozzle, Art. No. 00333438-01
Suction cups (in-house spare part, Motorola)
NOTE:
The procedure to be followed when exchanging these spare parts is not described here because
these jobs must be performed only by appropriately qualified personnel.
If such are not available, please contact Siemens SMD Service.
Vacuum Tooling for HS-50 Retrofit Instructions / User Manual
9 Maintenance Edition 12/00
48
0DLQWHQDQFH
Resources required:
– vacuum cleaner,
– clean, lint-free cloth
Vacuum plate (top plate of the tool): Clean/inspect contact surface and suction cups (suc-
tion openings) 9
:
Visually inspect the contact surface prior to starting the placement process.
:
Vacuum off the contact surface and the suction cups/suction openings (as also routine during
maintenance of the component tables).
If necessary, wipe off the surface afterwards with a clean, lint-free cloth.
Checking the silencer
:
Check the silencer for fouling at relatively long periods of time. If necessary, exchange the si-
lencer.
Suction cups
:
Exchange the suction cups of the tool when they become worn.