User Manual E-by-SIPLACE 用户手册.pdf - 第250页
5 Working with the machine User manual E by SIPLACE 5.16 Docking the changeover table in or out From software versio n SC 712.1 Edition 05/2019 250 5.16 Docking the changeover table in or out 5.16.1 Safety instructions f…
User manual E by SIPLACE 5 Working with the machine
From software version SC 712.1 Edition 05/2019 5.15 Refilling components
249
5.15 Refilling components
The online help contains information on refilling components with and without barcodes.
With tape feeder modules, make sure that you always splice on a new tape early enough so
that the feeder modules do not run out of components.
However, do not splice the tapes too early because if you wind the tape onto the new reel
after splicing the end of the old tape, the reel with the new tape may be overfilled. The tape
could then slip off the reel and become tangled. Under certain circumstances, this could
cause pick-up errors and prolonged down times.
5 Working with the machine User manual E by SIPLACE
5.16 Docking the changeover table in or out From software version SC 712.1 Edition 05/2019
250
5.16 Docking the changeover table in or out
5.16.1 Safety instructions for docking changeover tables in and out
5
5
Fig. 5.16 - 1 Safety instructions for docking the changeover table in or out
In addition, the changeover table can only be docked in if the protective covers are closed.
WARNING
DANGER OF CRUSHING!
Risk of crushing when docking and undocking the changeover table.
Always dock/undock the changeover table alone.
User manual E by SIPLACE 5 Working with the machine
From software version SC 712.1 Edition 05/2019 5.16 Docking the changeover table in or out
251
5.16.2 Docking out the changeover table
Go to the main view of the station software and select the Feeder module... icon and
then the
Locations icon.
5
Fig. 5.16 - 2 SC GUI - locations
Click on the icon to release the respective location and wait until the locking device
opens. For further information, refer to the station software Online Help.
Disconnect the power cable and the D-sub connection cable of the changeover table from the
machine.
With both hands on the handles, pull the changeover table out of the machine.
5
With both hands on the handles, pull the changeover table out of the machine.