User Manual E-by-SIPLACE 用户手册.pdf - 第316页
7 Maintenance User manual E by SIPLACE 7.1 Safety Information From software version SC 712.1 Edition 05 /2019 316 7 7 7 7 CAUTION Filter elements The cleaning and checking intervals given for inspect ing and re placing t…
User manual E by SIPLACE 7 Maintenance
From software version SC 712.1 Edition 05/2019 7.1 Safety Information
315
7 Maintenance
7
7
7.1 Safety Information
Please ensure all safety information in this section.
7
7
7
7
7
CAUTION
Maintenance - Further information
For further information on how to complete the tasks please visit the experience area on
the website: www.e-by-siplace.com
CAUTION
Before performing any cleaning and checking work or service work, a procedure of locking
and tagging must be followed. The procedure, when followed correctly eliminates the pos-
sibility of an employee being injured.
Please see further safety instructions on lock out tag in chapter 2 of this user manual.
CAUTION
For safety instructions of specific modules on the machine, please read the instructions in
chapter 2 of this user manual.
CAUTION
After switching off the machine, please wait for 5 minutes before doing work on the power
supply module.
CAUTION
Only qualified personnel
These cleaning and checking tasks may only be carried out by appropriately qualified per-
sonnel.
Caution, as used in this user manual, means that slight injury or damage to equipment
may occur if the caution instructions are not followed.
7 Maintenance User manual E by SIPLACE
7.1 Safety Information From software version SC 712.1 Edition 05/2019
316
7
7
7
7
CAUTION
Filter elements
The cleaning and checking intervals given for inspecting and replacing the filter
elements only apply to the specified compressed air quality (see
Section 3.2.4 on
page 105
). If other qualities are used, the intervals should be shortened accord-
ingly.
CAUTION
Ethanol
Always wear safety goggles and gloves when using concentrated ethanol to clean
modules.
If ethanol should accidentally get into your eyes, rinse your eyes immediately with
water.
CAUTION
Consumable materials
Observe the safety data sheets for consumable materials.
CAUTION
Cleaning and lubrication
Always use ethanol for cleaning - do not use solvents.
NEVER use compressed air to clean units inside the placement machine or modules.
User manual E by SIPLACE 7 Maintenance
From software version SC 712.1 Edition 05/2019 7.2 Maintenance on Base Machine
317
7.2 Maintenance on Base Machine
7
Base machine Every 6
months
Every 12
months
– Checking the Fans on the MGCU
X
– Checking the safety features on machines
X
– Checking and Cleaning/Replacing (if required) the Compressed Air Filter
X
– Cleaning/Replacing the Head Exhaust Air Filter
X
– Greasing and clean the X axis guide bearing
X
– Cleaning the Linear Guides of the X Axis
X
– Grease and clean the Y axis guide bearing
X
– Cleaning the Linear Guides of the Y Axis
X
– Cleaning the X Axis Scale
X
– Cleaning the Y Axis Scale
X
– Cleaning the Protective Covers
X
– Checking/Cleaning/Replacing the Gas Pressure Shock Absorbers on the
Protective Covers
X
– Replace the loose bearing lubrication system X axis and Y axis (if pres-
ent)
X
– Grease and clean the X and Y axis guide bearing
X