TM3200.Schedule task result displays_Manual.pdf - 第11页

SMT Software Eng ineering Group IM Operations Y AMAHA MOTOR CO., L TD.   MD OC-SOFT50138  1 1/13  3.6. Schedule T ask Result Display at the time of the movement abnormality W hen the fol lowing ab normities are dete…

100%1 / 13
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50138
10/13
“Schedule Task Last Date” is updated according to the following conditions.
Condition of the Schedule Task start Check Item Schedule Task Last Date
Vacuum Check
Nozzle Condition Check
When
“Check Item” of the Schedule
Task is executed by
the automatic
cycle.
Shaft Cleaning Blow
Updated.
IfnotScheduleTaskisnot
executedbecauseofsome
hardwaretroubles,it’snot
updated.
Vacuum Check
Nozzle Condition Check
When
“Check Item” of the Schedule
Task is executed by
the manual
operation.
(It is not related to setting of "Update
with manual operation".)
Shaft Cleaning Blow
Not updated
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50138
11/13
3.6. Schedule Task Result Display at the time of the movement
abnormality
When the following abnormities are detected during an execution of Schedule Task, it stops
with errors immediately. In this case, results list dialog is not displayed.
< About movement abnormal. >
- When the nozzle change failed.
- When the nozzle dropped to cleaning blow unit.
- When the system error occurred. (Es error)
etc.
If there is a nozzle with Schedule Task completed, only a result of the nozzle is displayed.
(The result is not displayed even on the Schedule Task monitor screen, when the Schedule
Task is canceled or emergency stop.)
when a movement abnormity occurs, remove the cause displayed on the error screen.
And then, operate those units of the each tab on the [unit] screen if it is possible to do by hand
in order to confirm a normalcy movement.
In addition, execute Schedule Task by the manual operation, and confirm a normal finish.
Refer to "3.4 Schedule Task manual operation from the Schedule Task monitor" for the
manual execution of the Schedule Task.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50138
12/13
4. Setting
4.1. Setting of the Schedule Task result display function
Set [Machine (VmSpec)] - [Specification Information] - [Schedule Specification].
The setting of this function can be edited only when "Check Item" of "Schedule
Specification" is selected to "Vacuum Check" or "Nozzle Check" or "Shaft Cleaning Blow".
Fig.3.7 Schedule specification screen
Set the Schedule Task result display function.