DECAN_S2_Maintenance(Eng_Ver4.3).pdf - 第63页
Mon thly Inspe ction chapt er 5 Advanced Chip Shooter DE CAN S2 M ain ten an ce H and bo ok 5 -2 Cleaning Head Spindle Monthly Inspe ction Step 4 . Re move th e nozzle Step 5. Put the c loth underneath the spi ndle Step …
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-1
Cleaning Head Spindle
Tool for Maintenance
Cleaning liquid, ultra fine fiber cloth, air gun
Measures
Step 1.
Move the Front X Frame and Rear X Frame to both
ends by referring to "Forward movement of the front
X-frame" on page 1-3 and "Backward movement of the
rear X-frame" on page 1-7.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
chapter 5
Monthly Inspection
Step 3.
Saparate the coil tube from vacuum filter
Cleaning Head Spindle
(Time required: 30min / No. M-1)
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-2
Cleaning Head Spindle
Monthly Inspection
Step 4.
Remove the nozzle
Step 5.
Put the cloth underneath the spindle
Step 6.
Cleaning the interior of the tube by an air gun.
Caution
Using the air gun without putting on goggles may cause injury to
operator's eyes. Be sure to wear goggles when using the air gun.
Step 7.
Release the emergency stop as described in "Releasing
'Emergency Stop' mode" on page 1-10 and perform the
operation again.
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-3
Checking and Cleaning Conveyor Sensor / Fiducial Mark
Checking and Cleaning Conveyor Sensor / Fiducial
Mark
Tool for Maintenance
Cleaning liquid, clean cloth
Measures
Step 1.
Move the Front X Frame assembly backward as
described in "Backward movement of the front X-frame"
on page 1-4.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Step 3.
Check the recognition accuracy of the corresponding
photo sensor as shown in the following figure. (The red
LED is turned on when an object is recognized.)
Rear
Front
Option(Conveyor 2-2-2)
Rear
Front
Option(Conveyor single)
Rear
Front
(Time required: 10min / No. M-2)