DECAN_S2_Maintenance(Eng_Ver4.3).pdf - 第80页

Mon thly Inspe ction chapt er 5 Advanced Chip Shooter DE CAN S2 M ain ten an ce H and bo ok 5-1 9 Cleaning and Lubricating X Frame LM Guide, Ball Screw Inje ct th e gre ase u sing a lu bric ator . (A1 ~ A4: LM G uid e, B…

100%1 / 92
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-18
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Monthly Inspection
Step 11.
Fasten the bolts fixing the cover in the order shown in
the following figure using a hex wrench (M3).
4
2
1
3
Step 12.
Fasten the cover tension adjustment bolts using a hex
wrench (M4).
Fasten the tension adjustment bolts so that the block of the grease
scatter prevention cover and the spacer come into close contact.
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-19
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Inject the grease using a lubricator.
(A1 ~ A4: LM Guide, B1: Ball screw)
(LM Guide: GREASE-GREASE_AFE-CA+70_
THK;SYNTHETIC,OL, Ball screw: GREASE GADUS S2
V220-2)
Caution
If the machine's operating environment is harsh, check its lubrication
status frequently.
Caution
The designated grease must be applied using the designated
lubricator in the designated manner. Other lubricating methods are
unacceptable.
Step 13.
Move the head assembly to the left and right three
times using a head assembly handle.
Step 14.
Release the emergency stop as described in "Releasing
'Emergency Stop' mode" on page 1-10 and perform the
operation again.
Monthly Inspection
chapter 5
Advanced Chip Shooter
DECAN S2 Maintenance Handbook
5-20
Cleaning and Lubricating Y Frame LM Guide
Monthly Inspection
Tool for Maintenance
Ultra-fine fiber cloth, Flat Brush, Lubricator, GREASE-GREASE_AFE-CA
Measures
Step 1.
Move the Front X Frame and Rear X Frame to both
ends by referring to "Forward movement of the front
X-frame" on page 1-3 and "Backward movement of the
rear X-frame" on page 1-7.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Step 3.
Clean the LM guide rail and ball screw using an ultra fine
fiber cloth.
Cleaning and Lubricating Y Frame LM Guide
(Time required: 60min / No. M-10)