Transport Rails Module.pdf - 第11页
TRANSPORT RAILS MODULE ADJUSTMENTS AND SETTINGS Chapter Issue 4 Jan 10 Technical Reference Manu al 16.11 the belt support plate of the front ra il is 0.25mm ± 0.05mm . 33. If adjustment is not necessary continue with S t…
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.10 Technical Reference Manual Chapter Issue 4 Jan 10
27. Confirm which type of rails are fitted to the machine and select the appropri-
ate rail setting jig.
28. Place the jig on the manual tooling plate ensuring that the location pins on
the underside of the jig abut the front face of the manual tooling plate. Check
there is no gap using a 0.05mm feeler gauge.
29. Secure the jig to the front rail using the two jig to rail thumbscrews.
30. Secure the jig to the rising table using the two jig to table thumbscrews.
31. Check that the location pins are up against the front edge of the manual
tooling plate using a 0.05mm feeler gauge, as in Step 28.
32. Using feeler gauges check that the gap between both alignment pads and
View on Left Hand Side
Manual Tooling Plate Location Pin
Rail Setting Jig
View on Rear of Transport Rails
Jig to Table Thumbscrews
Jig to Rail Thumbscrew
Jig to Rail Thumbscrew
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 4 Jan 10 Technical Reference Manual 16.11
the belt support plate of the front rail is 0.25mm ±0.05mm.
33. If adjustment is not necessary continue with Step 46.
Feeler Gauge
Alignment
Pad
Belt Support
Plate
View on Rear of Transport Rails
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.12 Technical Reference Manual Chapter Issue 4 Jan 10
34. Using a 3mm Allen key slacken the four securing bolts attaching the right
hand transport leg to the carriage nut.
35. Repeat Step 34 on the left hand transport leg.
36. Using a 4mm Allen key, through the access holes in the board edge guide,
slacken the four rail securing bolts (two each side).
37. Loosen the two jig to rail thumbscrews on the rail setting jig.
38. Adjust the front rail position to achieve the settings in Step 32.
39. Tighten the two jig to rail thumbscrews on the rail setting jig.
Rail Setting Jig
Securing Bolts
Securing Bolts
Transport Leg
View on Right Hand Side of Front Transport Rail
Carriage Nut
Access Holes
View on Inside of Front Rail
Left Hand End
View on Inside of Front Rail
Right Hand End
Access Holes
Board Edge Guides