Transport Rails Module.pdf - 第29页

TRANSPORT RAILS MODULE ADJUSTMENTS AND SETTINGS Chapter Issue 4 Jan 10 Technical Reference Manu al 16.29 52. Close the front printhead cover . 53. Press the System button. 54. Select Run Diagnost to energise the board cl…

100%1 / 44
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.28 Technical Reference Manual Chapter Issue 4 Jan 10
44. Place a height gauge on each of the steel dowels (A on the left and B on the
right).
45. Using the feeler gauges, ensure that the height gauge is not touching the
manual tooling plate.
46. Go to Step 52.
47. Manually move the front transport belt so that joint in the belt is over the drive
pulley.
48. Move the belt backwards and forwards to even out the belt tension.
49. Place a height gauge on top of the front transport belt aligned to the edge of
the board clamp (A on the left and B on the right).
50. Place a height gauge on top of the transport belt at the other edge of the
board clamp.
51. Using the feeler gauges, ensure that the height gauge is not touching the
manual tooling plate.
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 4 Jan 10 Technical Reference Manual 16.29
52. Close the front printhead cover.
53. Press the System button.
54. Select Run Diagnost to energise the board clamps.
55. Open the front printhead cover.
NOTE
Do not touch the transport rails as this could affect the readings.
56. Using the feeler gauges, check that the gap between the height gauge and
the manual tooling plate is 0.013˝ ±0.001˝.
57. If adjustment is not required, go to Step 65.
58. Each transport rail is supported by two rail height adjusters. Decide which
rail height adjusters need to be adjusted to achieve the correct height for the
rails.
59. Remove the appropriate safety cover(s).
60. Using a 13mm spanner, release the rail height adjuster locknut.
61. Using a 10mm spanner, adjust the rail height adjuster to achieve the height
in Step 56.
62. Tighten the locknut.
63. Recheck the measurements.
64. Repeat Steps 60 to 63 if necessary.
0.013 ±0.001²²
Manual Tooling Plate
Height Gauge
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.30 Technical Reference Manual Chapter Issue 4 Jan 10
65. Close the front printhead cover.
66. Press the System button.
67. Select Run Diagnost to release the board clamps.
68. Open the front printhead cover.
69. Remove the height gauges.
70. Remove the steel dowels (transport rails with round belts only).
71. Refit the transport belt (transport rails with round belts only).
72. Repeat Steps 38 to 71 for the rear transport rail.
73. Refit the safety cover(s).
74. Replace the tooling.
75. Refit the screen.
76. Close the front printhead cover.
77. Press the System button.
78. Select Exit.
79. Select Exit.
80. Select Back.
81. Select Load Screen.
82. Carry out the following calibrations:
• Vision Height, Camera System Module chapter refers
• Print Height, Rising Table Module chapter refers