Transport Rails Module.pdf - 第15页
TRANSPORT RAILS MODULE ADJUSTMENTS AND SETTINGS Chapter Issue 4 Jan 10 Technical Reference Manu al 16.15 8. Remove the H jigs and carry out the Front Rail Parallelism check as det ailed earlier in this chapter . 9. Refit…
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.14 Technical Reference Manual Chapter Issue 4 Jan 10
Rear Rail Parallelism
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
NOTE
Ensure Front Rail Parallelism has been carried out prior to commencing this
procedure. It is recommended this procedure is carried out by two persons.
1. Select Shut Down.
2. Select Continue.
3. Switch the mains isolator to OFF.
4. Remove the left and right machine side panels.
5. Using a pair of rail parallelism H jigs (DEK Part No. 158109) fit the jigs to the
front transport rail left and right leg linear guides. Ensure the linear guides
fit snugly in the jig slots.
6. Move the rear transport rail forwards, towards the front rail, until the rear leg
linear guides fit into the slots of the H jigs.
7. If both sets of linear guides fit snugly in the slots of the jigs, the rear transport
rail is parallel to the front rail, go to Step 15.
Front Rail
Rear Rail
Linear Guide Rails
Rear Right Transport Rail Leg
H Jig
View on Front Right Hand Side
Front Right
Transport
Rail Leg
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 4 Jan 10 Technical Reference Manual 16.15
8. Remove the H jigs and carry out the Front Rail Parallelism check as detailed
earlier in this chapter.
9. Refit the H jigs.
10. If both sets of linear guides fit snugly in the slots of the jigs, the rear transport
rail is parallel to the front rail, go to Step 15.
11. Loosen the four bolts securing the rear right hand side rail leg to the bearing
block.
12. Repeat Step 11 on the left hand side.
13. Reposition the rear rail until the linear guides fit snugly in the jig slots.
14. Tighten all eight securing bolts loosened in Steps 11 and 12.
15. Remove the H jigs.
16. Refit the machine panels removed in Step 4.
View on Right Hand Side of Transport Rails
Securing Bolts Securing Bolts
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.16 Technical Reference Manual Chapter Issue 4 Jan 10
Board Clamp Setting
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
NOTE
Board clamps are used in the following procedure, the procedure is identical for
foil-less clamps and snuggers.
1. Remove the belt guide from either side of the belt support plate.
2. Using feeler gauges, check that the gap between the rear board clamp and
the belt support plate is 0.325mm ±0.025mm. Ensure that the rear board
clamp is parallel to the belt support plate.
3. If adjustment is necessary, go to Step 8 for 250mm board clamps and
continue with Step 4 for 500mm board clamps.
Belt Support Plate
Belt Guide
Belt Guide
View on Rear Rail
Cross Section of Rear Rail Assembly
View on Rear Board Clamp
Rear Board Clamp
Belt Support Plate
Belt Support Plate
Rear Board Clamp
Moving Rail
0.325mm 0.025mm±