Transport Rails Module.pdf - 第38页
TRANSPORT RAILS MODULE REPLACEMENT PROCEDURES 16.38 Technical Reference Manu al Chapter Issue 4 Jan 10 6. On the rear rail, remove the two r ear snugger plate securing screws and remove the rear snugger plate. 7. On the …
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
Chapter Issue 4 Jan 10 Technical Reference Manual 16.37
Snuggers to Clamps
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
NOTE
This procedure is valid when converting to either board clamps or foil-less
clamps.
1. Select Open Cover Commands.
2. Select Carriage To Rear.
3. Select Unload Screen.
4. Open the front printhead cover.
5. Remove the screen from the machine.
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
16.38 Technical Reference Manual Chapter Issue 4 Jan 10
6. On the rear rail, remove the two rear snugger plate securing screws and
remove the rear snugger plate.
7. On the rear rail, remove the snugger base plate securing screws and
remove the snugger base plate.
8. On the front rail, remove the front snugger plate securing screws and
remove the front snugger plate.
9. Fit the board clamp to the rear rail and secure using the M4 pan head
screws.
10. Fit the board clamp to the front rail and secure using the M4 pan head
screws.
11. If foil-less clamps have been fitted continue with Step 12. If board clamps
have been fitted go to Step 14.
12. Fit the appropriate foil-less clamp to the rear rail and secure using the M4
pan head screws.
13. Repeat Step 12 for the front rail.
Rear Snugger Plate
Front Snugger Plate
Downstops
Plan View of Rail System
Snugger Base Plate
Downstops
Foil-less Clamp -
Adjustable Screen Mount (ASM)
Foil-less Clamp -
Fixed Width Chase
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
Chapter Issue 4 Jan 10 Technical Reference Manual 16.39
14. Locate the magnetic plate on the right hand side of the machine containing
the pneumatics for the snuggers.
15. Turn the pneumatic switch On.
16. Select Maintenance.
17. Select Machine Setup.
18. Select Basics.
19. Select Clamp Type.
20. Select Board Clamps.
21. Select Accept.
22. Select Back.
23. Select Back.
24. Select Back.
25. This completes the procedure if board clamps have been fitted. If foil-less
clamps have been fitted continue with Step 26.
26. Carry out Foil-less Clamp Height Adjustment in the Adjustments and Set-
tings section of this chapter.
NOTE
The Board Clamp Setting procedure is not required after snugger to board
clamp/foil-less clamp replacement.
Rear Rail Drive
Belt
1. At the rear of the rising table, slacken the adjustable idler pulley by means