Transport Rails Module.pdf - 第35页

TRANSPORT RAILS MODULE REPLACEMENT PROCEDURES Chapter Issue 4 Jan 10 Technical Reference Manu al 16.35 9. Fit the appropriate front snugger plate to th e front rail and secure using the M4 pan head scre ws. 10. Fit the r…

100%1 / 44
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
16.34 Technical Reference Manual Chapter Issue 4 Jan 10
6. Remove the securing screws from the rear board clamp and remove the
board clamp.
7. Repeat Step 6 for the front board clamp.
8. Fit the appropriate snugger base plate to the rear rail and secure using the
M4 pan head screws.
500mm Board Clamp Mechanism
Board Clamp Securing Screws
250mm Board Clamp Mechanism
Board Clamp Securing Screws
Snugger Base Plate -
Fixed Width Chase
Snugger Base Plate -
Adjustable Screen Mount (ASM)
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
Chapter Issue 4 Jan 10 Technical Reference Manual 16.35
9. Fit the appropriate front snugger plate to the front rail and secure using the
M4 pan head screws.
10. Fit the rear snugger plate, don’t tighten the M4 pan head securing screws.
11. Close the front printhead cover.
12. Press the System button.
Front Snugger Plate -
Fixed Width Chase
Front Snugger Plate -
Adjustable Screen Mount (ASM)
Rear Snugger Plate
Front Snugger Plate
Downstops
Plan View of Rail System
Snugger Base Plate
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
16.36 Technical Reference Manual Chapter Issue 4 Jan 10
13. Locate the magnetic plate on the right hand side of the machine containing
the pneumatics for the snuggers.
14. Turn the pneumatic switch On.
15. Load the product file to be printed, the rear rail moves to set the board width.
NOTE
With Auto Rail Width set to Disabled the rear rail does not set the board
width, but it can still be moved in diagnostics.
16. Select Maintenance.
17. Select Machine Setup.
18. Select Basics.
19. Select Clamp Type.
20. Select Snuggers.
21. Select Accept.
22. Select Back.
23. Select Back.
24. Select Back.
25. Carry out Snugger Base Plate Height Adjustment in the Adjustments and
Settings section of this chapter.
NOTE
The Board Clamp Setting procedure is not required after board clamp/foil-less
clamp to snugger replacement.